On Tue, Dec 17, 2013 at 02:42:35PM -0500, Matt Porter wrote:
Add a driver for the internal Broadcom Kona USB 2.0 PHY found
on the BCM281xx family of SoCs.
Signed-off-by: Matt Porter <redacted>
Kishon, are you ok with this driver ?
quoted hunk ↗ jump to hunk
+static int bcm_kona_usb2_probe(struct platform_device *pdev)
+{
+ struct device *dev = &pdev->dev;
+ struct bcm_kona_usb *phy;
+ struct resource *res;
+ struct phy *gphy;
+ struct phy_provider *phy_provider;
+
+ phy = devm_kzalloc(dev, sizeof(*phy), GFP_KERNEL);
+ if (!phy)
+ return -ENOMEM;
+
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ phy->regs = devm_ioremap_resource(&pdev->dev, res);
+ if (IS_ERR(phy->regs))
+ return PTR_ERR(phy->regs);
+
+ platform_set_drvdata(pdev, phy);
+
+ phy_provider = devm_of_phy_provider_register(dev,
+ of_phy_simple_xlate);
+ if (IS_ERR(phy_provider))
+ return PTR_ERR(phy_provider);
+
+ gphy = devm_phy_create(dev, &ops, NULL);
+ if (IS_ERR(gphy))
+ return PTR_ERR(gphy);
+
+ /* The Kona PHY supports an 8-bit wide UTMI interface */
+ phy_set_bus_width(gphy, 8);
+
+ phy_set_drvdata(gphy, phy);
I think this set_drvdata() should be done before registering the
provider, no ?
--
balbi