On Fri, 30 Nov 2012, Samuel Ortiz wrote:

Hi Viresh, Lee,

On Thu, Nov 29, 2012 at 08:10:18PM +0530, Viresh Kumar wrote:

quoted

From: Vipul Kumar Samar <redacted>

This patch extends existing DT support for stmpe devices. This updates:
- DT support from stmpe SPI and I2C drivers
- missing header files in stmpe.c
- stmpe_of_probe() with pwm, rotator and new bindings.
- Bindings are updated in binding document.

Signed-off-by: Vipul Kumar Samar <redacted>
Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org>
---
V4->V5:
------
- 2/3 and 3/3 merged.
- irq_trigger is kept same for non-DT booti.

@Lee: I haven't added your Acked-by, because this differs from your Acked
version.

Lee, are you ok with this one ? Could you give it a test ?

Okay, I've tested it, and it doesn't break anything.

But ... I don't see how the changes in the -i2c and -spi files
are of benefit either. When I boot without the ID table I still
get "stmpe-i2c 0-0040: stmpe1601 detected, chip id: 0x212".

What is it that actually uses the IDs?

Perhaps Viresh can shine some light on the matter?

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog