[RESEND PATCH 02/11] ARM: OMAP4: USB: Host: Panda board specific device tree node
From: Keshava Munegowda <hidden>
Date: 2012-10-31 14:26:43
Also in:
linux-omap
Subsystem:
the rest · Maintainer:
Linus Torvalds
OMAP4 panda board specific device tree node is included. In OMAP4 panda board, the port 1 is used in ULPI PHY mode. The port 1 is connected to a on board hub with ethernet interface. TODO: The clock bindings are not yet avilable for OMAP4. hence , USB hub specific clocks are exported as device tree string paramters. Will be changed to use the clock bindings later Signed-off-by: Keshava Munegowda <redacted> --- arch/arm/boot/dts/omap4-panda.dts | 33 +++++++++++++++++++++++++++++++++ 1 file changed, 33 insertions(+)
diff --git a/arch/arm/boot/dts/omap4-panda.dts b/arch/arm/boot/dts/omap4-panda.dts
index e8f927c..dad0df6 100644
--- a/arch/arm/boot/dts/omap4-panda.dts
+++ b/arch/arm/boot/dts/omap4-panda.dts@@ -184,3 +184,36 @@ &dmic { status = "disabled"; }; + +&usbhs { + /* + * Maximum fill 3 port info. + * port configured can be any one of the following values + * OMAP_USBHS_PORT_MODE_UNUSED = 0, + * OMAP_EHCI_PORT_MODE_PHY = 1, + * OMAP_EHCI_PORT_MODE_TLL = 2, + * OMAP_EHCI_PORT_MODE_HSIC = 3, + * OMAP_OHCI_PORT_MODE_PHY_6PIN_DATSE0 = 4, + * OMAP_OHCI_PORT_MODE_PHY_6PIN_DPDM = 5, + * OMAP_OHCI_PORT_MODE_PHY_3PIN_DATSE0 = 6, + * OMAP_OHCI_PORT_MODE_PHY_4PIN_DPDM = 7, + * OMAP_OHCI_PORT_MODE_TLL_6PIN_DATSE0 = 8, + * OMAP_OHCI_PORT_MODE_TLL_6PIN_DPDM = 9, + * OMAP_OHCI_PORT_MODE_TLL_3PIN_DATSE0 = 10, + * OMAP_OHCI_PORT_MODE_TLL_4PIN_DPDM = 11, + * OMAP_OHCI_PORT_MODE_TLL_2PIN_DATSE0 = 12, + * OMAP_OHCI_PORT_MODE_TLL_2PIN_DPDM = 13, + */ + port-0 = <1>; + port-1 = <0>; + port-2 = <0>; + + /* + * In some boards, the controller is always connected to hub + * the pandboard always has the hub connect to port0 of usbhs controller + */ + hub-power-gpio = <&gpio1 1 0>; + hub-reset-gpio = <&gpio2 30 0>; /* gpio 62 */ + hub-clk = "auxclk3_ck"; + hub-clkrate = <19200000>; +};
--
1.7.9.5