[PATCH v2 0/3] mtd: nand: OMAP: ELM error correction support for BCH ecc

Support to use ELM as BCH 4 & 8 bit error correction module. Also performance
enhancement by adding single shot read_page and write_page functions for the
nand flashes with page size less than 4 KB.

ELM module can be used to correct errors reported by BCH 4, 8 & 16 bit
ECC scheme. For now only 4 & 8 bit support is added.

BCH 4 & 8 bit error detection support is already available in mainline
kernel and works with software error correction.

This series is based on [1] and tested with RFC: OMAP GPMC bindings
patch series

1. linux-next/20121030

Changes since v1:
	- Erased page is identified by checking byte [13/7] in read
	  ecc. To filter out bit flips in OOB area, check 0 bits in
	  the byte greater than 4.
	- GPMC ecc engine configuration moves to omap2.c NAND driver.

Philip, Avinash (3):
  mtd: nand: omap2: Update nerrors using ecc.strength
  mtd: devices: elm: Add support for ELM error correction
  mtd: nand: omap2: Support for hardware BCH error correction

 Documentation/devicetree/bindings/mtd/elm.txt |   18 +
 drivers/mtd/devices/Makefile                  |    4 +-
 drivers/mtd/devices/elm.c                     |  420 +++++++++++++++++++
 drivers/mtd/nand/omap2.c                      |  542 +++++++++++++++++++++++--
 include/linux/platform_data/elm.h             |   54 +++
 include/linux/platform_data/mtd-nand-omap2.h  |    1 +
 6 files changed, 997 insertions(+), 42 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/mtd/elm.txt
 create mode 100644 drivers/mtd/devices/elm.c
 create mode 100644 include/linux/platform_data/elm.h