RE: [Patch v5 08/13] ARM: imx6q: add config-on-boot gpios

I haven't been following the thread, but just noticed it. Very similar
things (DT nodes for probed devices) are coming up quite a bit recently,
for example:

Re: Where to power on the wifi device before loading the driver.
http://www.spinics.net/lists/arm-kernel/msg180368.html

dt: rfkill-gpio: add bindings documentation
http://www.spinics.net/lists/linux-tegra/msg03977.html

I wonder if there's any kind of infra-structure or standardized bindings
that would be useful here?

Hi Stephen,
For your suggestion: 

sdhci@78000000 {
	compatible = "nvidia,tegra30-sdhci", "nvidia,tegra20-sdhci";
	reg = <0x78000000 0x200>;
	interrupts = <0 14 0x04>;

	sdio-device {
		reset-gpios = <...>;
		enable-gpios = <...>;
	};
};

I have a question, if reset-gpio or enable-gpio is not set, how bus (sd or usb) know
it is a sdio device as the wifi is not powered on at the time, it will not response host's
command,  the hub at usb bus is the same.


--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html