Hi Stephen, Arnd,

Been a while ;-)

On 05/21/2012 03:32 PM, Stephen Warren wrote:

On 05/21/2012 12:18 PM, Arnd Bergmann wrote:

quoted

On Monday 21 May 2012, Stephen Warren wrote:

quoted

quoted

The point with the direction was that it covers most cases and makes
them rather simple, while for the rare case where you need more than
two channels, you just use the otherwise optional named interface
rather than the numbered one. My feeling is that this also makes a
lot of sense at the driver API level: most dirvers just ask for the
read and write channels using a very simple interface, and those drivers
that have more than two will want to name them anyway.

How are you thinking of representing the direction in DT - as part of
the DMA request specifier, so in a DMAC-specific way?

If so, that seems a little odd; you have to request a DMA channel for
"TX", but then end up having the common code check all the entries in
the dmas property since it can't know which are TX, and then have the
wrong ones almost accidentally fail, since the DMAC will then determine
that it can't support TX on the RX DMA request IDs.

I think the direction must be encoded in a way that does not depend on
the binding for the specific controller. There are two ways I can see
how we might do it:

1. have separate property names for tx and rx channels, and probably
   one for combined rx/tx channels

quoted

2. define the second cell in each channel specifier to be the direction
   in a predefined format, followed by the other (controller specific)
   attributes, if any.

In this option, lets say bit 0 is 0==TX, 1==RX (or perhaps 2 bits if
combined TX/RX is needed)

Then, we could reserve say bits 7:1 as client DMA request ID.

And then have bits 31:8 as DMAC specific data.

Wouldn't that allow us to have our cake and eat it?

Sorry for not responding sooner.

It seems to me we were pretty close on alignment. In fact, I was quite
happy with Steven's 2nd to last proposal of  ...

simple 1 req:
dmas = <0 &dmac1 xxx>;

simple 2 req:
dmas = <0 &dmac1 xxx 1 &dmac1 yyy>;

multiple dmacs:
dmas = <0 &dmac1 xxx 0 &dmac2 zzz 1 &dmac1 yyy>;

Arnd, I know that you had some concerns. However, in the above case I
would expect that the 3rd parameter be optional and it can be some sort
of match variable. In other words, we don't care how the 32-bits are
encoded or what they represent but they would be used appropriately by
the xlate function being used. So the xlate and this "match" variable
would have to speak the same language.

I think that I prefer the idea of having a 3rd optional match variable
than encoding the DMA request ID and match data together in 1 32-bit
variable. However, not a big deal either way.

Cheers
Jon