Re: [PATCH v3 00/12] add imx usb driver for mx28/6x

Richard Zhao [off-list ref] writes:

On Wed, Jun 06, 2012 at 09:03:50AM +0300, Felipe Balbi wrote:

quoted

On Wed, Jun 06, 2012 at 10:27:22AM +0800, Shawn Guo wrote:

quoted

On Tue, Jun 05, 2012 at 06:02:13PM +0300, Felipe Balbi wrote:

quoted

Hi,

On Fri, May 25, 2012 at 10:24:13AM +0800, Richard Zhao wrote:

quoted

The work is based on  ci13xxx rework done by Alexander Shishkin.

Status:
  - this version only support host
  - usbotg controler works at host role

Changes since V2:
  - Rebase to Alex's tree
  - Use regulator to control vbus power
  - Remove ARCH check in Kconfig, but add OF_DEV check.
  - Other changes according laster version comments.

Richard Zhao (12):
  usb: otg: add notify_connect/notify_disconnect callback
  usb: chipidea: permit driver bindings pass phy pointer
  usb: ehci-hcd: notify phy when connect change
  usb: otg: add basic mxs phy driver support
  usb: chipidea: add imx platform driver
  ARM: imx6q: correct device name of usbphy and usb controller clock
    export
  ARM: imx6q: add config-on-boot gpios
  ARM: imx6q: add usbphy clocks
  ARM: imx6q: disable usb charger detector
  ARM: dts: imx6q-sabrelite: add usb devices
  ARM: mxs: clk_register_clkdev mx28 usb clocks
  ARM: dts: imx28-evk: add usb devices

how are we going to handle these series ? drivers/usb/otg/* parts are
mostly ok (I need to look deeper) but if I take drivers/usb/otg/* we
will have to delay drivers/usb/chipidea I guess...

So someone would have to take the whole series ? Who will be that
person? Alex, will it be you ?

I'm unsure about drivers/usb part, but arch/arm part should go via
arm-soc tree.

Yes, sure but the whole series is very "coupled" together... Maybe
Richard could try to split this series into things that can go through
arm-soc with no dependency on the other part and things that depend on
drivers/usb/*

I'm not clear. How does the ARM part depend on drivers/usb?
Shawn maybe could pick the ARM platform part. But the usb driver part
is divided into three maintainer, Balbi for otg, Alan for ehci-hcd,
Alex for Chipidea. Chipidea part depends on ehci-hcd and otg. So I
guess Greg could pick up all the driver part and Balbi, Alan and Alex
merge them back. Hope it could avoid loop dependency.

As long as Felipe and Alan give their acks and it's ok with everybody
else, I can pick up the whole drivers/usb part (patches 01-05).

Regards,
--
Alex
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html