Re: [PATCH v4] ARM: SPEAr600: Add device-tree support to SPEAr600 boards

On Friday 16 March 2012 13:09:18 Arnd Bergmann wrote:

On Friday 16 March 2012, Jean-Christophe PLAGNIOL-VILLARD wrote:

quoted

On 10:30 Fri 16 Mar     , Stefan Roese wrote:

quoted

This patch adds a generic target for SPEAr600 board that can be
configured via the device-tree. Currently the following devices
are supported via the devicetree:

- VIC interrupts
- PL011 UART
- PL061 GPIO
- Synopsys DW I2C
- Synopsys DW ethernet

Other peripheral devices (e.g. SMI flash, FSMC NAND flash etc) will
follow in later patches.

so drop USB, nand & co from the dtsi

this will be add later when the binding will documentated and Acked

I actually like to see the devices in there, and it already helped
figure out that there are two buses instead of just one. Maybe we
can agree on putting them in the file but commenting them out using
/* */ with an added notice that they will get enabled once we have
bindings?

It would be great to have a decision on this. I'm leaving for a short vacation 
in a few hours and would like to have the new (hopefully final) patch out 
before that.

Thanks for all your comments,
Stefan