Re: [PATCH 2/5 v3] ARM: at91: sam9g20 add i2c DT support

On 11:08 Thu 08 Mar     , Rob Herring wrote:

On 03/08/2012 02:50 AM, Jean-Christophe PLAGNIOL-VILLARD wrote:

quoted

For now on use i2c-gpio driver on the same pin as the hardware IP.

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj-sclMFOaUSTBWk0Htik3J/w@public.gmane.org>
Cc: Nicolas Ferre <redacted>
Cc: devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org
---
v3:

	update i2c binding (Rob comments)

Best Regards,
J.
 arch/arm/boot/dts/at91sam9g20.dtsi |   13 +++++++++++++
 1 files changed, 13 insertions(+), 0 deletions(-)

diff --git a/arch/arm/boot/dts/at91sam9g20.dtsi b/arch/arm/boot/dts/at91sam9g20.dtsi
index 4b0dc99..072b2da 100644
--- a/arch/arm/boot/dts/at91sam9g20.dtsi
+++ b/arch/arm/boot/dts/at91sam9g20.dtsi

@@ -189,4 +189,17 @@
 			status = "disabled";
 		};
 	};
+> > +	i2c-gpio@0 {

You updated the example, but not all the actual uses to i2c@0.

on purpose as on some soc we will have HW and soft binding

on the board you put the alias

Best Regards,
J.

Rob

quoted

+		compatible = "i2c-gpio";
+		gpios = <&pioA 23 0 /* sda */
+			 &pioA 24 0 /* scl */
+			>;
+		i2c-gpio,sda-open-drain;
+		i2c-gpio,scl-open-drain;
+		i2c-gpio,delay-us = <2>;	/* ~100 kHz */
+		#address-cells = <1>;
+		#size-cells = <0>;
+		status = "disabled";
+	};
 };

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel