Thread (24 messages) flat view 24 messages, 5 authors, 2011-12-07

Re: [PATCH v3 1/2] net/macb: add DT support for Cadence macb/gem driver

From: Nicolas Ferre <hidden>
Date: 2011-12-07 13:50:31
Also in: linux-arm-kernel, lkml, netdev

On 12/05/2011 12:59 PM, Nicolas Ferre :
From: Jean-Christophe PLAGNIOL-VILLARD<redacted>

Allow the device tree to provide the mac address and the phy mode.

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD<redacted>
[nicolas.ferre@atmel.com: change "compatible" node property, doc and DT hwaddr]
Signed-off-by: Nicolas Ferre<redacted>
[jamie@jamieiles.com: add "gem" compatibility strings and doc]
Acked-by: Jamie Iles<redacted>
David, can I have your acknowledgment on this patch so that I can send 
it through arm-soc git tree? This way it will reside on top of previous 
work by Jamie that is already in arm-soc git (for-next branch).

Thanks, best regards,
quoted hunk ↗ jump to hunk
---
v3: add "gem" compatibility strings
v2: modify macb_get_hwaddr_dt() parameter

  Documentation/devicetree/bindings/net/macb.txt |   24 ++++++++
  drivers/net/ethernet/cadence/macb.c            |   73 +++++++++++++++++++++---
  drivers/net/ethernet/cadence/macb.h            |    2 +
  3 files changed, 91 insertions(+), 8 deletions(-)
  create mode 100644 Documentation/devicetree/bindings/net/macb.txt
diff --git a/Documentation/devicetree/bindings/net/macb.txt b/Documentation/devicetree/bindings/net/macb.txt
new file mode 100644
index 0000000..2e24f05
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/macb.txt
@@ -0,0 +1,24 @@
+* Cadence MACB/GEM Ethernet controller
+
+Required properties:
+- compatible: Should be "cdns,[<chip>-]{macb|gem}"
+  Use "cdns,at91sam9260-macb" Atmel at91sam9260 and at91sam9263 SoCs.
+  Use "cdns,at32ap7000-macb" for other 10/100 usage or use the generic form: "cdns,macb".
+  Use "cnds,pc302-gem" for Picochip picoXcell pc302 and later devices based on
+  the Cadence GEM, or the generic form: "cdns,gem".
+- reg: Address and length of the register set for the device
+- interrupts: Should contain macb interrupt
+- phy-mode: String, operation mode of the PHY interface.
+  Supported values are: "mii", "rmii", "gmii", "rgmii".
+
+Optional properties:
+- local-mac-address: 6 bytes, mac address
+
+Examples:
+
+	macb0: ethernet@fffc4000 {
+		compatible = "cdns,at32ap7000-macb";
+		reg =<0xfffc4000 0x4000>;
+		interrupts =<21>;
+		phy-mode = "rmii";
+	};
diff --git a/drivers/net/ethernet/cadence/macb.c b/drivers/net/ethernet/cadence/macb.c
index 64d6146..baf1a0d 100644
--- a/drivers/net/ethernet/cadence/macb.c
+++ b/drivers/net/ethernet/cadence/macb.c
@@ -23,6 +23,8 @@
  #include<linux/platform_data/macb.h>
  #include<linux/platform_device.h>
  #include<linux/phy.h>
+#include<linux/of_device.h>
+#include<linux/of_net.h>

  #include "macb.h"
@@ -191,7 +193,6 @@ static int macb_mii_probe(struct net_device *dev)
  {
  	struct macb *bp = netdev_priv(dev);
  	struct phy_device *phydev;
-	struct macb_platform_data *pdata;
  	int ret;

  	phydev = phy_find_first(bp->mii_bus);
@@ -200,14 +201,11 @@ static int macb_mii_probe(struct net_device *dev)
  		return -1;
  	}

-	pdata = bp->pdev->dev.platform_data;
  	/* TODO : add pin_irq */

  	/* attach the mac to the phy */
  	ret = phy_connect_direct(dev, phydev,&macb_handle_link_change, 0,
-				 pdata&&  pdata->is_rmii ?
-				 PHY_INTERFACE_MODE_RMII :
-				 PHY_INTERFACE_MODE_MII);
+				 bp->phy_interface);
  	if (ret) {
  		netdev_err(dev, "Could not attach to PHY\n");
  		return ret;
@@ -1244,6 +1242,52 @@ static const struct net_device_ops macb_netdev_ops = {
  #endif
  };

+#if defined(CONFIG_OF)
+static const struct of_device_id macb_dt_ids[] = {
+	{ .compatible = "cdns,at32ap7000-macb" },
+	{ .compatible = "cdns,at91sam9260-macb" },
+	{ .compatible = "cdns,macb" },
+	{ .compatible = "cdns,pc302-gem" },
+	{ .compatible = "cdns,gem" },
+	{ /* sentinel */ }
+};
+
+MODULE_DEVICE_TABLE(of, macb_dt_ids);
+
+static int __devinit macb_get_phy_mode_dt(struct platform_device *pdev)
+{
+	struct device_node *np = pdev->dev.of_node;
+
+	if (np)
+		return of_get_phy_mode(np);
+
+	return -ENODEV;
+}
+
+static int __devinit macb_get_hwaddr_dt(struct macb *bp)
+{
+	struct device_node *np = bp->pdev->dev.of_node;
+	if (np) {
+		const char *mac = of_get_mac_address(np);
+		if (mac) {
+			memcpy(bp->dev->dev_addr, mac, ETH_ALEN);
+			return 0;
+		}
+	}
+
+	return -ENODEV;
+}
+#else
+static int __devinit macb_get_phy_mode_dt(struct platform_device *pdev)
+{
+	return -ENODEV;
+}
+static int __devinit macb_get_hwaddr_dt(struct macb *bp)
+{
+	return -ENODEV;
+}
+#endif
+
  static int __init macb_probe(struct platform_device *pdev)
  {
  	struct macb_platform_data *pdata;
@@ -1318,10 +1362,22 @@ static int __init macb_probe(struct platform_device *pdev)
  	config |= macb_dbw(bp);
  	macb_writel(bp, NCFGR, config);

-	macb_get_hwaddr(bp);
-	pdata = pdev->dev.platform_data;
+	err = macb_get_hwaddr_dt(bp);
+	if (err<  0)
+		macb_get_hwaddr(bp);
+
+	err = macb_get_phy_mode_dt(pdev);
+	if (err<  0) {
+		pdata = pdev->dev.platform_data;
+		if (pdata&&  pdata->is_rmii)
+			bp->phy_interface = PHY_INTERFACE_MODE_RMII;
+		else
+			bp->phy_interface = PHY_INTERFACE_MODE_MII;
+	} else {
+		bp->phy_interface = err;
+	}

-	if (pdata&&  pdata->is_rmii)
+	if (bp->phy_interface == PHY_INTERFACE_MODE_RMII)
  #if defined(CONFIG_ARCH_AT91)
  		macb_or_gem_writel(bp, USRIO, (MACB_BIT(RMII) |
  					       MACB_BIT(CLKEN)));
@@ -1444,6 +1500,7 @@ static struct platform_driver macb_driver = {
  	.driver		= {
  		.name		= "macb",
  		.owner	= THIS_MODULE,
+		.of_match_table	= of_match_ptr(macb_dt_ids),
  	},
  };
diff --git a/drivers/net/ethernet/cadence/macb.h b/drivers/net/ethernet/cadence/macb.h
index 1931078..335e288 100644
--- a/drivers/net/ethernet/cadence/macb.h
+++ b/drivers/net/ethernet/cadence/macb.h
@@ -532,6 +532,8 @@ struct macb {
  	unsigned int 		link;
  	unsigned int 		speed;
  	unsigned int 		duplex;
+
+	phy_interface_t		phy_interface;
  };

  static inline bool macb_is_gem(struct macb *bp)

-- 
Nicolas Ferre
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help