Hi Roman.

Now with proper CC.

Roman Mamedov - 17.08.18, 14:50:

On Fri, 17 Aug 2018 14:28:25 +0200

Martin Steigerwald [off-list ref] wrote:

quoted

quoted

First off, keep in mind that the SSD firmware doing compression
only
really helps with wear-leveling.  Doing it in the filesystem will
help not only with that, but will also give you more space to
work with.> 

While also reducing the ability of the SSD to wear-level. The more
data I fit on the SSD, the less it can wear-level. And the better I
compress that data, the less it can wear-level.

Do not consider SSD "compression" as a factor in any of your
calculations or planning. Modern controllers do not do it anymore,
the last ones that did are SandForce, and that's 2010 era stuff. You
can check for yourself by comparing write speeds of compressible vs
incompressible data, it should be the same. At most, the modern ones
know to recognize a stream of binary zeroes and have a special case
for that.

Interesting. Do you have any backup for your claim?

As for general comment on this thread, always try to save the exact
messages you get when troubleshooting or getting failures from your
system. Saying just "was not able to add" or "btrfs replace not
working" without any exact details isn't really helpful as a bug
report or even as a general "experiences" story, as we don't know
what was the exact cause of those, could that have been avoided or
worked around, not to mention what was your FS state at the time (as
in "btrfs fi show" and "fi df").

I had a screen.log, but I put it on the filesystem after the 
backup was made, so it was lost.

Anyway, the reason for not being able to add the device was the read 
only state of the BTRFS, as I wrote. Same goes for replace. I was able 
to read the error message just fine. AFAIR the exact wording was "read 
only filesystem".

In any case: It was a experience report, no request for help, so I don´t 
see why exact error messages are absolutely needed. If I had a support 
inquiry that would be different, I agree.

Thanks,
-- 
Martin