On Tue, 25 Feb 2020 at 01:20, Stephen Warren [off-list ref] wrote:

On 2/24/20 4:18 PM, Dmitry Osipenko wrote:

quoted

All NVIDIA Tegra devices use a special partition table format for the
internal storage partitioning. Most of Tegra devices have GPT partition
in addition to TegraPT, but some older Android consumer-grade devices do
not or GPT is placed in a wrong sector, and thus, the TegraPT is needed
in order to support these devices properly in the upstream kernel. This
patch adds support for NVIDIA Tegra Partition Table format that is used
at least by all NVIDIA Tegra20 and Tegra30 devices.

quoted

diff --git a/arch/arm/mach-tegra/tegra.c b/arch/arm/mach-tegra/tegra.c

quoted

+static void __init tegra_boot_config_table_init(void)
+{
+     void __iomem *bct_base;
+     u16 pt_addr, pt_size;
+
+     bct_base = IO_ADDRESS(TEGRA_IRAM_BASE) + TEGRA_IRAM_BCT_OFFSET;

This shouldn't be hard-coded. IIRC, the boot ROM writes a BIT (Boot
Information Table) to a fixed location in IRAM, and there's some value
in the BIT that points to where the BCT is in IRAM. In practice, it
might work out that the BCT is always at the same place in IRAM, but
this certainly isn't guaranteed. I think there's code in U-Boot which
extracts the BCT location from the BIT? Yes, see
arch/arm/mach-tegra/ap.c:get_odmdata().

So, have you considered using the command line partition option,
rather than adding yet another partition scheme to the kernel?

In principle, you would let the boot loader scan for the partitions,
likely from machine specific code in U-boot. Then you append these to
the kernel command line and let block/partitions/cmdline.c scan for
it.

Kind regards
Uffe