[PATCH 02/10] sdhci: aspeed: Add SDR50 support
From: Andrew Jeffery <hidden>
Date: 2021-10-26 00:31:53
Also in:
linux-arm-kernel, linux-clk, linux-devicetree, linux-mmc, lkml, openbmc
Hi Chin-Ting, Sorry for the delay in looking at your series. On Wed, 22 Sep 2021, at 20:01, Chin-Ting Kuo wrote:
quoted hunk ↗ jump to hunk
From the analog waveform analysis result, SD/SDIO controller of AST2600 cannot always work well with 200MHz. The upper bound stable frequency for SD/SDIO controller is 100MHz. Thus, SDR50 supported bit, instead of SDR104, in capability 2 register should be set in advance. Signed-off-by: Chin-Ting Kuo <chin-ting_kuo@aspeedtech.com> --- drivers/mmc/host/sdhci-of-aspeed.c | 8 ++++++++ 1 file changed, 8 insertions(+)diff --git a/drivers/mmc/host/sdhci-of-aspeed.cb/drivers/mmc/host/sdhci-of-aspeed.c index 6e4e132903a6..c6eaeb02e3f9 100644--- a/drivers/mmc/host/sdhci-of-aspeed.c +++ b/drivers/mmc/host/sdhci-of-aspeed.c@@ -35,6 +35,8 @@ #define ASPEED_SDC_CAP1_1_8V (0 * 32 + 26) /* SDIO{14,24} */ #define ASPEED_SDC_CAP2_SDR104 (1 * 32 + 1) +/* SDIO{14,24} */
I don't think we need to duplicate this comment.
+#define ASPEED_SDC_CAP2_SDR50 (1 * 32 + 0)
Can we keep the defines in increasing bit order (i.e. put ASPEED_SDC_CAP2_SDR50 above ASPEED_SDC_CAP2_SDR104)?
quoted hunk ↗ jump to hunk
struct aspeed_sdc { struct clk *clk;@@ -410,11 +412,17 @@ static int aspeed_sdhci_probe(structplatform_device *pdev) sdhci_get_of_property(pdev); if (of_property_read_bool(np, "mmc-hs200-1_8v") || + of_property_read_bool(np, "sd-uhs-sdr50") ||
Minor formatting issue, but can you make sure all the conditions are aligned vertically from the left?
of_property_read_bool(np, "sd-uhs-sdr104")) {
aspeed_sdc_set_slot_capability(host, dev->parent, ASPEED_SDC_CAP1_1_8V,
true, slot);
}
+ if (of_property_read_bool(np, "sd-uhs-sdr50")) {
+ aspeed_sdc_set_slot_capability(host, dev->parent, ASPEED_SDC_CAP2_SDR50,
+ true, slot);
+ }
+
if (of_property_read_bool(np, "sd-uhs-sdr104")) {
aspeed_sdc_set_slot_capability(host, dev->parent, ASPEED_SDC_CAP2_SDR104,
true, slot);
--
2.17.1