Re: [PATCH 2/2] arm64: dts: ti: k3-am64: Set MMC1_CLK pin as OUTPUT

Sai,

On 9/28/26 12:00 PM, Judith Mendez wrote:

Hi Sai,

On 9/27/26 10:30 PM, Sai Sree Kartheek Adivi wrote:

quoted

From: Judith Mendez <jm@ti.com>

MMC clock pins must be configured as OUTPUT-only per TRM specification [0]
with receiver disabled (RXACTIVE bit = 0). Change MMC1_CLK from PIN_INPUT
to PIN_OUTPUT in AM64 device trees to match documentation.

There was an issue showing up in automated testing that I was not sure
if it was attributed to this patch series. So I was waiting to see the
error again to debug. Not 100% confident this should go upstream yet.

On top to this, this change also needs to be added for all AM64 based
boards. But as said before, I think we need to wait a bit before
sending this patch (:

~ Judith