Re: [PATCH v2 2/2] dt-bindings: mfd: ti,keystone-devctrl: Convert to DT schema

Hi,

On Tue, Aug 18, 2026 at 12:31 PM Krzysztof Kozlowski [off-list ref] wrote:

On Sun, Aug 16, 2026 at 12:23:00AM +0530, Bhargav Joshi wrote:

quoted

Convert the Texas Instruments Keystone Device State Control binding from
legacy text format to DT schema.

During the conversion, the following updates were made:
- Add "simple-mfd" to compatibles matching existing dts usage.
- Add required bus properties #address-cells, #size-cells, and ranges
  which were missing in text binding.
- Document child nodes gpio, interrupt-controller, and reset-controller.

Signed-off-by: Bhargav Joshi <redacted>
---
Note: Running dt_binding_check on patch will yield a warning for
'ti,keystone-reset' in the example block. The YAML conversion patch for
that child node is already in progress here:
https://lore.kernel.org/linux-devicetree/20260813-ti-keystone-reset-v1-1-189389503324@gmail.com/ (local)
---

You need to send dependencies together, either in patchset or even one
patch, depending on the case. If this has warnings then it cannot be
applied.

Yes, but ti,keystone-reset is now already merged into linux-next, so i can
wait until it is merged into mainline then resend the patch without warning.

Best regards,
Bhargav