Thread (2 messages) 2 messages, 2 authors, 3d ago
WARM3d

[PATCH net-next] dt-bindings: net: fix spelling errors

From: shaikh.kamal <hidden>
Date: 2026-07-26 05:25:10
Also in: imx, linux-devicetree, lkml, netdev
Subsystem: motorcomm phy driver, networking drivers, open firmware and flattened device tree bindings, the rest · Maintainers: Frank, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds

Fix spelling errors reported by codespell:

  encompases -> encompasses (stm32-dwmac, sti-dwmac, nxp,dwmac-imx)
  curren     -> current     (motorcomm,yt8xxx)

No functional change.

Signed-off-by: shaikh.kamal <redacted>
---
 Documentation/devicetree/bindings/net/motorcomm,yt8xxx.yaml | 4 ++--
 Documentation/devicetree/bindings/net/nxp,dwmac-imx.yaml    | 2 +-
 Documentation/devicetree/bindings/net/sti-dwmac.txt         | 2 +-
 Documentation/devicetree/bindings/net/stm32-dwmac.yaml      | 4 ++--
 4 files changed, 6 insertions(+), 6 deletions(-)
diff --git a/Documentation/devicetree/bindings/net/motorcomm,yt8xxx.yaml b/Documentation/devicetree/bindings/net/motorcomm,yt8xxx.yaml
index 26688e2302ea..e8108cde0f59 100644
--- a/Documentation/devicetree/bindings/net/motorcomm,yt8xxx.yaml
+++ b/Documentation/devicetree/bindings/net/motorcomm,yt8xxx.yaml
@@ -59,7 +59,7 @@ properties:
       be configured with hardware pull-up resistors to match the SOC voltage
       (usually 1.8V).
       The software can read the registers to obtain the LDO voltage and configure
-      the legal drive strength(curren).
+      the legal drive strength(current).
       =====================================================
       | voltage |        current Available (uA)           |
       |   1.8v  | 1200 2100 2700 2910 3110 3600 3970 4350 |
@@ -76,7 +76,7 @@ properties:
       be configured with hardware pull-up resistors to match the SOC voltage
       (usually 1.8V).
       The software can read the registers to obtain the LDO voltage and configure
-      the legal drive strength(curren).
+      the legal drive strength(current).
       =====================================================
       | voltage |        current Available (uA)           |
       |   1.8v  | 1200 2100 2700 2910 3110 3600 3970 4350 |
diff --git a/Documentation/devicetree/bindings/net/nxp,dwmac-imx.yaml b/Documentation/devicetree/bindings/net/nxp,dwmac-imx.yaml
index e5db346beca9..75c9820ee60b 100644
--- a/Documentation/devicetree/bindings/net/nxp,dwmac-imx.yaml
+++ b/Documentation/devicetree/bindings/net/nxp,dwmac-imx.yaml
@@ -72,7 +72,7 @@ properties:
           - description: the offset of the GPR register
     description:
       Should be phandle/offset pair. The phandle to the syscon node which
-      encompases the GPR register, and the offset of the GPR register.
+      encompasses the GPR register, and the offset of the GPR register.
 
   nvmem-cells: true
 
diff --git a/Documentation/devicetree/bindings/net/sti-dwmac.txt b/Documentation/devicetree/bindings/net/sti-dwmac.txt
index e16287c06e5e..6e7e77da49bc 100644
--- a/Documentation/devicetree/bindings/net/sti-dwmac.txt
+++ b/Documentation/devicetree/bindings/net/sti-dwmac.txt
@@ -9,7 +9,7 @@ The device node has following properties.
 Required properties:
  - compatible	: "st,stih407-dwmac"
  - st,syscon : Should be phandle/offset pair. The phandle to the syscon node which
-   encompases the glue register, and the offset of the control register.
+   encompasses the glue register, and the offset of the control register.
  - st,gmac_en: this is to enable the gmac into a dedicated sysctl control
    register available on STiH407 SoC.
  - pinctrl-0: pin-control for all the MII mode supported.
diff --git a/Documentation/devicetree/bindings/net/stm32-dwmac.yaml b/Documentation/devicetree/bindings/net/stm32-dwmac.yaml
index 987254900d0d..fac882198a46 100644
--- a/Documentation/devicetree/bindings/net/stm32-dwmac.yaml
+++ b/Documentation/devicetree/bindings/net/stm32-dwmac.yaml
@@ -91,12 +91,12 @@ properties:
     items:
       - minItems: 2
         items:
-          - description: phandle to the syscon node which encompases the glue register
+          - description: phandle to the syscon node which encompasses the glue register
           - description: offset of the control register
           - description: field to set mask in register
     description:
       Should be phandle/offset pair. The phandle to the syscon node which
-      encompases the glue register, the offset of the control register and
+      encompasses the glue register, the offset of the control register and
       the mask to set bitfield in control register
 
   st,ext-phyclk:
base-commit: 1590cf0329716306e948a8fc29f1d3ee87d3989f
-- 
2.43.0

Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help