From: Luke Wang <redacted>

Check pm_runtime_force_resume() return value in resume. If it fails
(clock enable failure), return immediately since accessing hardware
registers on an unclocked device would cause a kernel panic.

The early return intentionally skips enable_irq() and
sdhci_disable_irq_wakeups() because the IRQ handler reads
SDHCI_INT_STATUS, which would also fault without clocks. The PM runtime
usage counter leak only affects this already-broken device instance and
is an acceptable tradeoff to preserve system stability.

Remove the return value check for mmc_gpio_set_cd_wake(host->mmc, false)
since disable_irq_wake() called internally always returns 0.

Also return 0 explicitly on the success path instead of propagating
stale return values.

Signed-off-by: Luke Wang <redacted>
---
 drivers/mmc/host/sdhci-esdhc-imx.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
index 6920f0425508..586a1debf098 100644
--- a/drivers/mmc/host/sdhci-esdhc-imx.c
+++ b/drivers/mmc/host/sdhci-esdhc-imx.c

@@ -2124,12 +2124,12 @@ static int sdhci_esdhc_resume(struct device *dev)
 			dev_warn(dev, "Failed to restore pinctrl state\n");
 	}
 
-	pm_runtime_force_resume(dev);
-
-	ret = mmc_gpio_set_cd_wake(host->mmc, false);
+	ret = pm_runtime_force_resume(dev);
 	if (ret)
 		return ret;
 
+	mmc_gpio_set_cd_wake(host->mmc, false);
+
 	/* re-initialize hw state in case it's lost in low power mode */
 	sdhci_esdhc_imx_hwinit(host);
 

@@ -2156,7 +2156,7 @@ static int sdhci_esdhc_resume(struct device *dev)
 
 	pm_runtime_put_autosuspend(dev);
 
-	return ret;
+	return 0;
 }
 
 static int sdhci_esdhc_runtime_suspend(struct device *dev)

-- 
2.34.1