[PATCH v3 8/9] mtd: rawnand: sunxi: fix typos in comments
From: Richard Genoud <richard.genoud@bootlin.com>
Date: 2026-03-17 14:25:10
Also in:
linux-sunxi, lkml
Subsystem:
memory technology devices (mtd), nand flash subsystem, the rest · Maintainers:
Miquel Raynal, Richard Weinberger, Vignesh Raghavendra, Linus Torvalds
Fix lenghts -> lengths and chuncks -> chunks Signed-off-by: Richard Genoud <richard.genoud@bootlin.com> --- drivers/mtd/nand/raw/sunxi_nand.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/mtd/nand/raw/sunxi_nand.c b/drivers/mtd/nand/raw/sunxi_nand.c
index 81e491be3563..3d2580d39e70 100644
--- a/drivers/mtd/nand/raw/sunxi_nand.c
+++ b/drivers/mtd/nand/raw/sunxi_nand.c@@ -272,7 +272,7 @@ static inline struct sunxi_nand_chip *to_sunxi_nand(struct nand_chip *nand) * * @has_mdma: Use mbus dma mode, otherwise general dma * through MBUS on A23/A33 needs extra configuration. - * @has_ecc_block_512: If the ECC can handle 512B or only 1024B chuncks + * @has_ecc_block_512: If the ECC can handle 512B or only 1024B chunks * @has_ecc_clk: If the controller needs an ECC clock. * @has_mbus_clk: If the controller needs a mbus clock. * @legacy_max_strength:If the maximize strength function was off by 2 bytes
@@ -294,7 +294,7 @@ static inline struct sunxi_nand_chip *to_sunxi_nand(struct nand_chip *nand) * @nstrengths: Size of @ecc_strengths * @max_ecc_steps: Maximum supported steps for ECC, this is also the * number of user data registers - * @user_data_len_tab: Table of lenghts supported by USER_DATA_LEN register + * @user_data_len_tab: Table of lengths supported by USER_DATA_LEN register * The table index is the value to set in NFC_USER_DATA_LEN * registers, and the corresponding value is the number of * bytes to write