[PATCH 3/4] ARM: dts: mba6ulx: add boot phase properties
flat view
STALE250d
SUPERSEDED
From: Max Merchel <hidden>
Date: 2026-02-18 13:25:03
Also in:
imx, linux-devicetree, lkml
Subsystem:
arm/freescale imx / mxc / layerscape arm architecture, the rest, tq systems board & driver support · Maintainers:
Frank Li, Sascha Hauer, Linus Torvalds
Status: Superseded by v2 (posted 2026-02-20). [go to v2]
Revision v1 (2 revisions archived).
Revisions (2)
- v1 current
- v2 [diff against previous]
Add boot phase properties to MBa6ULx device tree. Signed-off-by: Max Merchel <redacted> --- arch/arm/boot/dts/nxp/imx/mba6ulx.dtsi | 6 ++++++ 1 file changed, 6 insertions(+)
diff --git a/arch/arm/boot/dts/nxp/imx/mba6ulx.dtsi b/arch/arm/boot/dts/nxp/imx/mba6ulx.dtsi
index 65fde4f52587..1fda60d62ffe 100644
--- a/arch/arm/boot/dts/nxp/imx/mba6ulx.dtsi
+++ b/arch/arm/boot/dts/nxp/imx/mba6ulx.dtsi@@ -95,6 +95,7 @@ reg_mba6ul_3v3: regulator-mba6ul-3v3 { regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; regulator-always-on; + bootph-pre-ram; }; reg_mba6ul_5v0: regulator-mba6ul-5v0 {
@@ -336,6 +337,7 @@ &sai1 { &uart1 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_uart1>; + bootph-pre-ram; status = "okay"; };
@@ -392,6 +394,7 @@ &usdhc1 { no-1-8-v; no-mmc; no-sdio; + bootph-all; status = "okay"; };
@@ -399,6 +402,7 @@ &wdog1 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_wdog1>; fsl,ext-reset-output; + bootph-pre-ram; status = "okay"; };
@@ -494,6 +498,7 @@ pinctrl_uart1: uart1grp { MX6UL_PAD_UART1_TX_DATA__UART1_DCE_TX 0x1b0b1 MX6UL_PAD_UART1_RX_DATA__UART1_DCE_RX 0x1b0b1 >; + bootph-pre-ram; }; pinctrl_uart3: uart3grp {
@@ -542,6 +547,7 @@ MX6UL_PAD_UART1_CTS_B__GPIO1_IO18 0x0001b099 /* CD */ MX6UL_PAD_UART1_RTS_B__GPIO1_IO19 0x0001b099 >; + bootph-all; }; pinctrl_usdhc1_100mhz: usdhc1-100mhz-grp {
--
2.43.0