On 1/5/26 07:55, Nishanth Menon wrote:

On 20:51-20251230, Kendall Willis wrote:

quoted

Change the status of the wkup_uart0_interconnect node to enabled. The
target-module node sets the UART SYSC and SYSS registers to allow wakeup
from WKUP UART in DeepSleep low power mode.

Signed-off-by: Kendall Willis <redacted>
---
  arch/arm64/boot/dts/ti/k3-am62l3-evm.dts | 4 ++++
  1 file changed, 4 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-am62l3-evm.dts b/arch/arm64/boot/dts/ti/k3-am62l3-evm.dts
index cae04cce337366b50928d39b0c888550b14e43d3..02b1a1c76b2ee05d49cd69d199a6aacdb1973fa0 100644
--- a/arch/arm64/boot/dts/ti/k3-am62l3-evm.dts
+++ b/arch/arm64/boot/dts/ti/k3-am62l3-evm.dts

@@ -359,3 +359,7 @@ &usb1 {
  	pinctrl-names = "default";
  	pinctrl-0 = <&usb1_default_pins>;
  };
+
+&wkup_uart0_interconnect {
+	status = "okay";
+};

don't we need to set status okay and provide pinmux for wkup_uart?

No, only the interconnect target node needs to be enabled because it 
manages the SYSC register. The SYSC register configures the WKUP_UART to 
be able to wakeup the SoC from system suspend. This allows the WKUP_UART 
to be wakeup capable even if it is reserved by firmware.

Best,
Kendall

quoted

-- 
2.34.1