On Fri, 28 Nov 2025 10:03:59 +0800, Chaoyi Chen wrote:

From: Chaoyi Chen <redacted>

The RK3399 SoC integrates two USB/DP combo PHYs, each of which
supports software-configurable pin mapping and DisplayPort lane
assignment. These capabilities enable the PHY itself to handle both
mode switching and orientation switching, based on the Type-C plug
orientation and USB PD negotiation results.

While an external Type-C controller is still required to detect cable
attachment and report USB PD events, the actual mode and orientation
switching is performed internally by the PHY through software
configuration. This allows the PHY to act as a Type-C multiplexer for
both data role and DP altmode configuration.

To reflect this hardware design, this patch introduces a new
"mode-switch" property for the dp-port node in the device tree bindings.
This property indicates that the connected PHY is capable of handling
Type-C mode switching itself.

Signed-off-by: Chaoyi Chen <redacted>
Acked-by: Krzysztof Kozlowski <redacted>
---

(no changes since v5)

Changes in v4:
- Remove "|" in description.

Changes in v3:
- Add more descriptions to clarify the role of the PHY in switching.

Changes in v2:
- Reuse dp-port/usb3-port in rk3399-typec-phy binding.

 .../devicetree/bindings/phy/rockchip,rk3399-typec-phy.yaml  | 6 ++++++
 1 file changed, 6 insertions(+)

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/slimbus/slimbus.example.dtb: slim@28080000 (qcom,slim-ngd-v1.5.0): 'audio-codec@1,0' does not match any of the regexes: '^pinctrl-[0-9]+$', '^slim@[0-9a-f]+$'
	from schema $id: http://devicetree.org/schemas/slimbus/qcom,slim-ngd.yaml
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/slimbus/slimbus.example.dtb: slim@28080000 (qcom,slim-ngd-v1.5.0): #address-cells: 1 was expected
	from schema $id: http://devicetree.org/schemas/slimbus/qcom,slim-ngd.yaml
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/slimbus/slimbus.example.dtb: slim@28080000 (qcom,slim-ngd-v1.5.0): 'dmas' is a required property
	from schema $id: http://devicetree.org/schemas/slimbus/qcom,slim-ngd.yaml
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/slimbus/slimbus.example.dtb: slim@28080000 (qcom,slim-ngd-v1.5.0): 'dma-names' is a required property
	from schema $id: http://devicetree.org/schemas/slimbus/qcom,slim-ngd.yaml
Documentation/devicetree/bindings/thermal/thermal-sensor.example.dtb: /example-0/soc/thermal-sensor@c263000: failed to match any schema with compatible: ['qcom,sdm845-tsens', 'qcom,tsens-v2']
Documentation/devicetree/bindings/thermal/thermal-sensor.example.dtb: /example-0/soc/thermal-sensor@c263000: failed to match any schema with compatible: ['qcom,sdm845-tsens', 'qcom,tsens-v2']
Documentation/devicetree/bindings/thermal/thermal-sensor.example.dtb: /example-0/soc/thermal-sensor@c265000: failed to match any schema with compatible: ['qcom,sdm845-tsens', 'qcom,tsens-v2']
Documentation/devicetree/bindings/thermal/thermal-sensor.example.dtb: /example-0/soc/thermal-sensor@c265000: failed to match any schema with compatible: ['qcom,sdm845-tsens', 'qcom,tsens-v2']

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20251128020405.90-6-kernel@airkyi.com

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.