Re: [PATCH] ARM: dts: broadcom: rpi: Switch to V3D firmware clock
From: Stefan Wahren <wahrenst@gmx.net>
Date: 2025-10-28 18:04:50
Also in:
linux-devicetree
Hi Mark, Am 27.10.25 um 17:51 schrieb Mark Brown:
On Mon, Oct 27, 2025 at 05:43:21PM +0100, Stefan Wahren wrote:quoted
Am 27.10.25 um 13:07 schrieb Mark Brown:quoted
No. This is happening in mainline (was originally reported against pending-fixes) so wasn't affected by all the module breakage, that was separate.I think, i got confused because I was only able to reproduce this issue with the broken linux-next. So I was going for the wrong cause :-( Do you use arm64/defconfig as kernel config?Yes, it's just plain defconfig.quoted
Is there a HDMI cable connected?No, the boards only have ethernet, serial and power connected.
I switched to the same Raspberry Pi firmware 2023-10-17 and added U-Boot 2024.01 as second stage bootloader, but still not able to reproduce. Looking at the LAVA output, I'm seeing this as the very first issue(s): [ 13.480675] platform wifi-pwrseq: deferred probe pending: pwrseq_simple: reset control not ready [ 13.489095] platform bcm2835-power: deferred probe pending: bcm2835-power: Failed to get clock v3d Are critical drivers like clk_raspberrypi and resert_gpio listed in lsmod? Is there anything special in the config.txt? Regards