Hi,

On Mon, Jul 21, 2025 at 4:18 PM Laura Nao [off-list ref] wrote:

This patch series extends the MediaTek LVTS thermal driver to support the
MT8196 SoC.

MT8196 uses a positive temp_factor for temperature conversion, requiring
slight adjustments in the conversion logic.

To support this, the series introduces:

- A new struct lvts_platform_ops to allow platform-specific
  conversion logic between raw sensor values and temperature
- A variant of the lvts_temp_to_raw() implementation for SoCs with positive
  temp_factor values
- Platform data and controller definitions for MT8196

I see the GPU and APU thermal sensors were left out. Was there a reason
for this?

Thanks
ChenYu

Laura Nao (9):
  dt-bindings: thermal: mediatek: Add LVTS thermal controller support
    for MT8196
  thermal/drivers/mediatek/lvts: Make number of calibration offsets
    configurable
  thermal/drivers/mediatek/lvts: Guard against zero temp_factor in
    lvts_raw_to_temp
  thermal: mediatek: lvts: Add platform ops to support alternative
    conversion logic
  thermal/drivers/mediatek/lvts: Add lvts_temp_to_raw variant for
    positive temp_factor
  thermal/drivers/mediatek/lvts: Add support for ATP mode
  thermal/drivers/mediatek/lvts: Support MSR offset for 16-bit
    calibration data
  thermal/drivers/mediatek/lvts_thermal: Add MT8196 support
  dt-bindings: nvmem: mediatek: efuse: Add support for MT8196

 .../bindings/nvmem/mediatek,efuse.yaml        |   1 +
 .../thermal/mediatek,lvts-thermal.yaml        |   2 +
 drivers/thermal/mediatek/lvts_thermal.c       | 315 ++++++++++++++++--
 .../thermal/mediatek,lvts-thermal.h           |  26 ++
 4 files changed, 325 insertions(+), 19 deletions(-)

--
2.39.5