Re: [PATCH v7 0/6] imx8mp: add support for the IMX AIPSTZ bridge

Hello Laurentiu,

On 7/3/25 10:51, Laurentiu Mihalcea wrote:

On 7/3/2025 11:11 AM, Ahmad Fatoum wrote:

quoted

Hello Laurentiu,

On 10.06.25 18:01, Laurentiu Mihalcea wrote:

quoted

From: Laurentiu Mihalcea <redacted>

The AIPSTZ bridge offers some security-related configurations which can
be used to restrict master access to certain peripherals on the bridge.

Normally, this could be done from a secure environment such as ATF before
Linux boots but the configuration of AIPSTZ5 is lost each time the power
domain is powered off and then powered on. Because of this, it has to be
configured each time the power domain is turned on and before any master
tries to access the peripherals (e.g: AP, CM7, DSP, on i.MX8MP).

Sorry if this has been asked before, but I hoped the cover letter or patch
3/6 would explain if it were.

What is the default configuration for the AIPSTZ before this series?

the default configuration is the reset configuration since AIPSTZ registers go
back to their reset values during domain power cycling.

quoted

I assume the SAIs under AIPS5 can be accessed by SDMA already, so why was
changing the AIPSTZ settings needed for the DSP to work?

AFAIK SDMA transactions to peripherals don't go through AIPS5. They use SPBA, which
is why SDMA works even w/o this series. As for the DSP: transactions to peripherals go
through AIPS5. With the reset configuration, the DSP is not allowed to access said peripherals,
which is why this series was needed.

I see. Thanks for tackling this issue and your explanation.

Cheers,
Ahmad

-- 
Pengutronix e.K.                  |                             |
Steuerwalder Str. 21              | http://www.pengutronix.de/  |
31137 Hildesheim, Germany         | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686  | Fax:   +49-5121-206917-5555 |