On Wed, Jan 29, 2025 at 05:23:50PM -0600, Bjorn Helgaas wrote:

On Tue, Jan 28, 2025 at 05:07:35PM -0500, Frank Li wrote:

quoted

Rename `cpu_addr` to `parent_bus_addr` in the DesignWare ATU configuration.
The ATU translates parent bus addresses to PCI addresses, which are often
the same as CPU addresses but can differ in systems where the bus fabric
translates addresses before passing them to the PCIe controller. This
renaming clarifies the purpose and avoids confusion.

Based on dw_pcie_ep_inbound_atu() below, I guess the ATU can also
translate PCI addresses from incoming DMA to parent bus addresses?

Yes, but root complex don't use it. Only EP use it. because most PCI root
complex system doesn't transfer incoming address, which generally use iommu
to do that. Linux already allow a simple map by use dt's dma-ranges and dma
API already handle it.

previous 'cpu_addr' is actually 'dma_bus_addr'.

It's worth noting here that this patch only renames the member, and
IIUC, parent_bus_addr still incorrectly contains CPU physical
addresses.

Anyway, call 'cpu_addr' for dw_pcie_ep_inbound_atu is wrong. Only one place
call dw_pcie_ep_inbound_atu(), that's dw_pcie_ep_set_bar(), which use
epf_bar->phys_addr, I think name 'phys_addr' is okay because most case it
is refer to dma address space.

Frank

quoted

+++ b/drivers/pci/controller/dwc/pcie-designware-ep.c

@@ -128,7 +128,7 @@ static int dw_pcie_ep_write_header(struct pci_epc *epc, u8 func_no, u8 vfunc_no,
 }

 static int dw_pcie_ep_inbound_atu(struct dw_pcie_ep *ep, u8 func_no, int type,
-				  dma_addr_t cpu_addr, enum pci_barno bar,
+				  dma_addr_t parent_bus_addr, enum pci_barno bar,
 				  size_t size)