Re: [RFC PATCH v3 5/5] mm: support large folios swapin as a whole

On Tue, Jun 11, 2024 at 12:23:41PM GMT, Barry Song wrote:

On Tue, Jun 11, 2024 at 8:43 AM Shakeel Butt [off-list ref] wrote:

quoted

On Thu, Mar 14, 2024 at 08:56:17PM GMT, Chuanhua Han wrote:
[...]

quoted

quoted

So in the common case, swap-in will pull in the same size of folio as was
swapped-out. Is that definitely the right policy for all folio sizes? Certainly
it makes sense for "small" large folios (e.g. up to 64K IMHO). But I'm not sure
it makes sense for 2M THP; As the size increases the chances of actually needing
all of the folio reduces so chances are we are wasting IO. There are similar
arguments for CoW, where we currently copy 1 page per fault - it probably makes
sense to copy the whole folio up to a certain size.

For 2M THP, IO overhead may not necessarily be large? :)
1.If 2M THP are continuously stored in the swap device, the IO
overhead may not be very large (such as submitting bio with one
bio_vec at a time).
2.If the process really needs this 2M data, one page-fault may perform
much better than multiple.
3.For swap devices like zram,using 2M THP might also improve
decompression efficiency.

Sorry for late response, do we have any performance data backing the
above claims particularly for zswap/swap-on-zram cases?

no need to say sorry. You are always welcome to give comments.

this, combining with zram modification, not only improves compression
ratio but also reduces CPU time significantly. you may find some data
here[1].

granularity   orig_data_size   compr_data_size   time(us)
4KiB-zstd      1048576000       246876055        50259962
64KiB-zstd     1048576000       199763892        18330605

On mobile devices, We tested the performance of swapin by running
100 iterations of swapping in 100MB of data ,and the results were
as follows.the swapin speed increased by about 45%.

                time consumption of swapin(ms)
lz4 4k                  45274
lz4 64k                 22942

zstdn 4k                85035
zstdn 64k               46558

Thanks for the response. Above numbers are actually very fascinating and
counter intuitive (at least to me). Do you also have numbers for 2MiB
THP? I am assuming 64k is the right balance between too small or too
large. Did you experiment on server machines as well?

[1] https://lore.kernel.org/linux-mm/20240327214816.31191-1-21cnbao@gmail.com/ (local)

Thanks
Barry