[RESEND PATCH v2 3/4] arm64: dts: ti: k3-j721s2-common-proc-board: Remove Pinmux for CTS and RTS in wkup_uart0
From: Bhavya Kapoor <hidden>
Date: 2024-02-12 10:44:28
Also in:
linux-devicetree, lkml
Subsystem:
arm/texas instruments k3 architecture, the rest · Maintainers:
Nishanth Menon, Vignesh Raghavendra, Tero Kristo, Linus Torvalds
Only Tx and Rx Signal lines for wkup_uart0 are brought out on the Common Proc Board through SoM, but CTS and RTS signal lines are not brought on the board. Thus, remove pinmux for CTS and RTS signal lines for wkup_uart0 in J721S2. Signed-off-by: Bhavya Kapoor <redacted> --- arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts | 2 -- 1 file changed, 2 deletions(-)
diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
index 361365bb5523..6371cb1c1fe7 100644
--- a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts@@ -190,8 +190,6 @@ J721S2_IOPAD(0x038, PIN_OUTPUT, 0) /* (AB28) MCASP0_ACLKX.MCAN5_TX */ &wkup_pmx2 { wkup_uart0_pins_default: wkup-uart0-default-pins { pinctrl-single,pins = < - J721S2_WKUP_IOPAD(0x070, PIN_INPUT, 0) /* (E25) WKUP_GPIO0_6.WKUP_UART0_CTSn */ - J721S2_WKUP_IOPAD(0x074, PIN_OUTPUT, 0) /* (F28) WKUP_GPIO0_7.WKUP_UART0_RTSn */ J721S2_WKUP_IOPAD(0x048, PIN_INPUT, 0) /* (D28) WKUP_UART0_RXD */ J721S2_WKUP_IOPAD(0x04c, PIN_OUTPUT, 0) /* (D27) WKUP_UART0_TXD */ >;
--
2.34.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel