Thread (10 messages) 10 messages, 3 authors, 2024-02-07

Re: [PATCH 2/2] arm64: dts: allwinner: h616: Add Sipeed Longan SoM 3H and Pi 3H board support

From: Jisheng Zhang <jszhang@kernel.org>
Date: 2024-02-03 12:49:40
Also in: linux-devicetree, linux-sunxi, lkml

On Tue, Jan 09, 2024 at 09:37:03PM +0100, Jernej Škrabec wrote:
Hi Jisheng,
Hi Jernej,
Andre gave you thorough review already, so just one additional comment
below.

Dne četrtek, 28. december 2023 ob 15:56:47 CET je Jisheng Zhang napisal(a):
quoted
The Sipeed Longan SoM 3H is a system on module based on the Allwinner
H618 SoC. The SoM features:

- Four ARM Cortex-A53 cores, Mali-G31 MP2 GPU
- 2/4 GiB LPDDR4 DRAM SoMs
- AXP313a PMIC
- eMMC

The Sipeed Longan PI 3H is a development board based on the above SoM.
The board features:
- Longan SoM 3H
- Raspberry-Pi-1 compatible GPIO header
- 2 USB 2.0 host port
- 1 USB 2.0 type C port (power supply + OTG)
- MicroSD slot
- 1Gbps Ethernet port (via RTL8211 PHY)
- HDMI port
- WiFi/BT chip

Add the devicetree file describing the currently supported features,
namely PMIC, LEDs, UART, SD card, eMMC, USB and Ethernet.

Signed-off-by: Jisheng Zhang <jszhang@kernel.org>
---
 arch/arm64/boot/dts/allwinner/Makefile        |   1 +
 .../sun50i-h618-longan-module-3h.dtsi         |  82 +++++++++++
 .../dts/allwinner/sun50i-h618-longanpi-3h.dts | 133 ++++++++++++++++++
 3 files changed, 216 insertions(+)
 create mode 100644 arch/arm64/boot/dts/allwinner/sun50i-h618-longan-module-3h.dtsi
 create mode 100644 arch/arm64/boot/dts/allwinner/sun50i-h618-longanpi-3h.dts
diff --git a/arch/arm64/boot/dts/allwinner/Makefile b/arch/arm64/boot/dts/allwinner/Makefile
index 3aca6787a167..00db504a9b8c 100644
--- a/arch/arm64/boot/dts/allwinner/Makefile
+++ b/arch/arm64/boot/dts/allwinner/Makefile
@@ -42,4 +42,5 @@ dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h616-bigtreetech-cb1-manta.dtb
 dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h616-bigtreetech-pi.dtb
 dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h616-orangepi-zero2.dtb
 dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h616-x96-mate.dtb
+dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h618-longanpi-3h.dtb
 dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h618-orangepi-zero3.dtb
diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h618-longan-module-3h.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h618-longan-module-3h.dtsi
new file mode 100644
index 000000000000..88a7d287b73c
--- /dev/null
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h618-longan-module-3h.dtsi
@@ -0,0 +1,82 @@
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Copyright (C) Jisheng Zhang <jszhang@kernel.org>
+ */
+
+/dts-v1/;
+
+#include "sun50i-h616.dtsi"
+
+/ {
+	model = "Sipeed Longan Module 3H";
+	compatible = "sipeed,longan-module-3h", "allwinner,sun50i-h618";
+};
+
+&mmc2 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&mmc2_pins>;
+	vmmc-supply = <&reg_dldo1>;
+	vqmmc-supply = <&reg_aldo1>;
+	bus-width = <8>;
+	non-removable;
+	cap-mmc-hw-reset;
+	mmc-ddr-1_8v;
I think above is superfluous if hs200 is also defined.
I read the mmc code again, IMHO, mmc-ddr-1_8v and mmc-hs200-1_8v
are for different caps, the former is for MMC_CAP_1_8V_DDR and
the later is for MMC_CAP2_HS200_1_8V_SDR, I must admit that
mmc-hs200-1_8v does imply mmc-ddr-1_8v in normal host controllers
but they are different, and I found other dts files also contain
both, so I kept this as is in v2.

Thanks
quoted
+	mmc-hs200-1_8v;
+	status = "okay";
+};
+
 

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help