Re: [PATCH v3 3/7] clk: samsung: gs101: add support for cmu_peric1
From: Tudor Ambarus <tudor.ambarus@linaro.org>
Date: 2024-01-30 09:00:01
Also in:
linux-clk, linux-devicetree, linux-samsung-soc, lkml
On 1/29/24 17:46, André Draszik wrote:
CMU_PERIC1 is the clock management unit used for the peric1 block which
is used for additional USI, I3C and PWM interfaces/busses. Add support
for muxes, dividers and gates of cmu_peric1, except for
CLK_GOUT_PERIC1_IP which isn't well described in the datasheet and
which downstream also ignores (similar to cmu_peric0).
Two clocks have been marked as CLK_IS_CRITICAL for the following
reason:
* disabling them makes it impossible to access any peric1
registers, (including those two registers).
* disabling gout_peric1_lhm_axi_p_peric1_i_clk sometimes has the
additional effect of making the whole system unresponsive.
One clock marked as CLK_IGNORE_UNUSED needs to be kept on until we have
updated the respective driver for the following reason:
* gout_peric1_gpio_peric1_pclk is required by the pinctrl
configuration. With this clock disabled, reconfiguring the pins
(for USI/I2C, USI/UART) will hang during register access.
Since pinctrl-samsung doesn't support a clock at the moment, we
just keep the kernel from disabling it at boot, until we have an
update for pinctrl-samsung, at which point we'll drop the flag.
Signed-off-by: André Draszik <andre.draszik@linaro.org>
Reviewed-by: Sam Protsenko <semen.protsenko@linaro.org>
Reviewed-by: Peter Griffin <peter.griffin@linaro.org>Looks good to me: Reviewed-by: Tudor Ambarus <tudor.ambarus@linaro.org> _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel