Re: [PATCH 1/3] media: rc: meson-ir: support rc driver type RC_DRIVER_SCANCODE
From: Zelong Dong <hidden>
Date: 2023-09-06 10:38:00
Also in:
linux-amlogic, linux-devicetree, linux-media
在 2023/9/1 16:02, Sean Young 写道:
On Thu, Aug 31, 2023 at 08:13:22PM +0800, Zelong Dong wrote:quoted
在 2023/8/29 15:39, Sean Young 写道:quoted
On Fri, Aug 25, 2023 at 07:53:08PM +0800, zelong dong wrote:quoted
From: Zelong Dong<redacted> Meson IR Controller supports hardware decoder in Meson-S4 and later SoC. So far, protocol NEC could be decoded by hardware decoder.On Meson-S4, only the hardware decoder for NEC can be used using this driver. Does the Meson-S4 hardware support software decoding? If software decoding could be used, then any protocol could be supported, not just NEC. Also, out of interest, is there are documentation available for this hardware? Thanks, SeanYes, IR driver still supports SW decoding on Meson-S4. The decode mode could be changed by 'support_hw_decoder'.This requires changing the source code, it cannot be done at runtime.quoted
If IR Controller works in SW decoding, driver will be registered by RC_DRIVER_IR_RAW and allows all protocol. Otherwise, driver will be registered by RC_DRIVER_SCANCODE and only allows NEC. 489 if (ir->rc->driver_type == RC_DRIVER_IR_RAW) { 490 ir->rc->allowed_protocols = RC_PROTO_BIT_ALL_IR_DECODER; 491 ir->rc->rx_resolution = MESON_RAW_TRATE; 492 ir->rc->min_timeout = 1; 493 ir->rc->timeout = IR_DEFAULT_TIMEOUT; 494 ir->rc->max_timeout = 10 * IR_DEFAULT_TIMEOUT; 495 } else if (ir->rc->driver_type == RC_DRIVER_SCANCODE) { 496 ir->rc->allowed_protocols = RC_PROTO_BIT_NEC; 497 ir->rc->change_protocol = meson_ir_hw_decoder_init; 498 }There are other drivers too which can do hardware decoding and software decoding. Ideally we should have a mechanism to switch between them at runtime, but as-is rc-core does not provide for this.
Anything else I should update for this patchset?
quoted
Do you get Meson-S4 datasheet? Please refer to chapter 13.5 Infrared Remote.I did not get it, unfortunately. Any help would be appreciated, thanks.
Sorry, this document is not public and I don't have permission to share with you. Perhaps you could apply to xiaohong.zou@amlogic.com for Meson-S4 datasheet.
Other than that, the driver does look fine. Nothing to hold up merging for. I'll apply it when I can. Thanks, Sean
_______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel