[PATCH v3 6/8] dt_bindings: rs485: Correct delay values

From: Lino Sanfilippo <redacted>

Currently the documentation claims that a maximum of 1000 msecs is allowed
for RTS delays. However nothing actually checks the values read from device
tree/ACPI and so it is possible to set much higher values.

There is already a maximum of 100 ms enforced for RTS delays that are set
via the uart TIOCSRS485 ioctl. To be consistent with that use the same
limit for DT/ACPI values.

Although this change is visible to userspace the risk of breaking anything
when reducing the max delays from 1000 to 100 ms should be very low, since
100 ms is already a very high maximum for delays that are usually rather in
the usecs range.

Signed-off-by: Lino Sanfilippo <redacted>
Acked-by: Rob Herring <robh@kernel.org>
---
 Documentation/devicetree/bindings/serial/rs485.yaml | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/serial/rs485.yaml b/Documentation/devicetree/bindings/serial/rs485.yaml
index f2c9c9fe6aa7..90a1bab40f05 100644
--- a/Documentation/devicetree/bindings/serial/rs485.yaml
+++ b/Documentation/devicetree/bindings/serial/rs485.yaml

@@ -22,12 +22,12 @@ properties:
         - description: Delay between rts signal and beginning of data sent in
             milliseconds. It corresponds to the delay before sending data.
           default: 0
-          maximum: 1000
+          maximum: 100
         - description: Delay between end of data sent and rts signal in milliseconds.
             It corresponds to the delay after sending data and actual release
             of the line.
           default: 0
-          maximum: 1000
+          maximum: 100
 
   rs485-rts-active-low:
     description: drive RTS low when sending (default is high).

-- 
2.25.1

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel