Re: [PATCH v3 5/6] dt-bindings: net: dsa: make reset optional and add rgmii-mode to mt7531

Am 7. Mai 2022 22:01:22 MESZ schrieb Krzysztof Kozlowski [off-list ref]:

On 07/05/2022 19:04, Frank Wunderlich wrote:

quoted

From: Frank Wunderlich <redacted>

Make reset optional as driver already supports it, 

I do not see the connection between hardware needing or not needing a
reset GPIO and a driver supporting it or not... What does it mean?

My board has a shared gpio-reset between gmac and switch, so both will resetted if it is asserted. Currently it is set to the gmac and is aquired exclusive. Adding it to switch results in 2 problems:

- due to exclusive and already mapped to gmac, switch driver exits as it cannot get the reset-gpio again.
- if i drop the reset from gmac and add to switch, it resets the gmac and this takes too long for switch to get up. Of course i can increase the wait time after reset,but dropping reset here was the easier way.

Using reset only on gmac side brings the switch up.

quoted

allow port 5 as
cpu-port 

How do you allow it here?

Argh, seems i accidentally removed this part and have not recognized while checking :(

It should only change description of reg for ports to:

"Port address described must be 5 or 6 for CPU port and from 0 to 5 for user ports."

regards Frank

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel