Re: [RFC PATCH 1/1] pinctrl: imx: Reduce printk message level for empty nodes
From: Linus Walleij <hidden>
Date: 2022-03-15 00:48:56
Also in:
linux-gpio
On Thu, Feb 24, 2022 at 10:42 AM Alexander Stein [off-list ref] wrote:
iomuxc_snvs from imx6ull supports 2 boot mode and 10 tamper pins. Probably most users won't use them, causing this error message during boot: no groups defined in /soc/bus@2200000/iomuxc-snvs@2290000 This is actually not an error in this case, so reduce the level accordingly. Signed-off-by: Alexander Stein <redacted> --- This issue was raised during release test: Why is there an error if nothing is wrong? Memory only devices are enabled by default, which I agree, but this causes the mentioned error message unconditionally, unless some muxing is configured. I would argue that even a warning is not correct either, nothing is wrong here.
Patch applied. Yours, Linus Walleij _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel