[PATCH 2 3/9] serial: stm32: remove redundant code in rs485_config
flat view
STALE1708d
From: Lino Sanfilippo <LinoSanfilippo@gmx.de>
Date: 2022-02-16 00:19:24
Also in:
linux-serial, lkml
Subsystem:
the rest, tty layer and serial drivers · Maintainers:
Linus Torvalds, Greg Kroah-Hartman, Jiri Slaby
In uart_set_rs485_config() the serial core already ensures that only one of both options RTS on send or RTS after send is set. It also assigns the passed serial_rs485 struct to the uart port. So remove the check and the assignment from the drivers rs485_config() function to avoid redundancy. Signed-off-by: Lino Sanfilippo <LinoSanfilippo@gmx.de> --- drivers/tty/serial/stm32-usart.c | 9 ++------- 1 file changed, 2 insertions(+), 7 deletions(-)
diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 1b3a611ac39e..6a014168102c 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c@@ -107,8 +107,6 @@ static int stm32_usart_config_rs485(struct uart_port *port, stm32_usart_clr_bits(port, ofs->cr1, BIT(cfg->uart_enable_bit)); - port->rs485 = *rs485conf; - rs485conf->flags |= SER_RS485_RX_DURING_TX; if (rs485conf->flags & SER_RS485_ENABLED) {
@@ -128,13 +126,10 @@ static int stm32_usart_config_rs485(struct uart_port *port, rs485conf->delay_rts_after_send, baud); - if (rs485conf->flags & SER_RS485_RTS_ON_SEND) { + if (rs485conf->flags & SER_RS485_RTS_ON_SEND) cr3 &= ~USART_CR3_DEP; - rs485conf->flags &= ~SER_RS485_RTS_AFTER_SEND; - } else { + else cr3 |= USART_CR3_DEP; - rs485conf->flags |= SER_RS485_RTS_AFTER_SEND; - } writel_relaxed(cr3, port->membase + ofs->cr3); writel_relaxed(cr1, port->membase + ofs->cr1);
--
2.34.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel