[PATCH 05/24] ARM: dts: exynos: override pins by label in Peach Pit
From: Krzysztof Kozlowski <hidden>
Date: 2021-12-31 16:20:31
Also in:
linux-devicetree, linux-gpio, linux-samsung-soc, lkml
Subsystem:
the rest · Maintainer:
Linus Torvalds
Using node paths to extend or override a device tree node is error prone. If there was a typo error, a new node will be created instead of extending the existing node. This will lead to run-time errors that could be hard to detect. A mistyped label on the other hand, will cause a dtc compile error (during build time). Signed-off-by: Krzysztof Kozlowski <redacted> --- arch/arm/boot/dts/exynos5420-peach-pit.dts | 44 +++++++++++----------- 1 file changed, 22 insertions(+), 22 deletions(-)
diff --git a/arch/arm/boot/dts/exynos5420-peach-pit.dts b/arch/arm/boot/dts/exynos5420-peach-pit.dts
index e76fb104db19..1ae5528e9ebf 100644
--- a/arch/arm/boot/dts/exynos5420-peach-pit.dts
+++ b/arch/arm/boot/dts/exynos5420-peach-pit.dts@@ -868,27 +868,26 @@ pmic_dvs_1: pmic-dvs-1 { }; }; -&pinctrl_1 { - /* Adjust WiFi drive strengths lower for EMI */ - sd1_clk: sd1-clk { - samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; - }; +/* pinctrl_1 */ +/* Adjust WiFi drive strengths lower for EMI */ +&sd1_bus1 { + samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; +}; - sd1_cmd: sd1-cmd { - samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; - }; +&sd1_bus4 { + samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; +}; - sd1_bus1: sd1-bus-width1 { - samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; - }; +&sd1_bus8 { + samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; +}; - sd1_bus4: sd1-bus-width4 { - samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; - }; +&sd1_clk { + samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; +}; - sd1_bus8: sd1-bus-width8 { - samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; - }; +&sd1_cmd { + samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; }; &pinctrl_2 {
@@ -907,12 +906,13 @@ pmic_dvs_3: pmic-dvs-3 { }; }; -&pinctrl_3 { - /* Drive SPI lines at x2 for better integrity */ - spi2-bus { - samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; - }; +/* pinctrl_3*/ +/* Drive SPI lines at x2 for better integrity */ +&spi2_bus { + samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV3>; +}; +&pinctrl_3 { /* Drive SPI chip select at x2 for better integrity */ ec_spi_cs: ec-spi-cs { samsung,pins = "gpb1-2";
--
2.32.0
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel