[PATCH v1 3/4] ARM: dts: imx6qdl-vicut1: add CAN termination support
From: Oleksij Rempel <o.rempel@pengutronix.de>
Date: 2021-11-22 12:43:46
Also in:
dri-devel, linux-devicetree, lkml
Subsystem:
the rest · Maintainer:
Linus Torvalds
The gpio1 0 pin is controlling CAN termination, not USB H1 VBUS. So, remove wrong regulator and assign this GPIO to the new DT CAN termination property. Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de> --- arch/arm/boot/dts/imx6qdl-vicut1.dtsi | 12 ++---------- 1 file changed, 2 insertions(+), 10 deletions(-)
diff --git a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
index b9e305774fed..1ac7e13249d2 100644
--- a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi@@ -126,15 +126,6 @@ reg_3v3: regulator-3v3 { regulator-max-microvolt = <3300000>; }; - reg_h1_vbus: regulator-h1-vbus { - compatible = "regulator-fixed"; - regulator-name = "h1-vbus"; - regulator-min-microvolt = <5000000>; - regulator-max-microvolt = <5000000>; - gpio = <&gpio1 0 GPIO_ACTIVE_HIGH>; - enable-active-high; - }; - reg_otg_vbus: regulator-otg-vbus { compatible = "regulator-fixed"; regulator-name = "otg-vbus";
@@ -212,6 +203,8 @@ IMX_AUDMUX_V2_PTCR_SYN IMX_AUDMUX_V2_PDCR_RXDSEL(0) &can1 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_can1>; + termination-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>; + termination-ohms = <150>; status = "okay"; };
@@ -492,7 +485,6 @@ &uart5 { }; &usbh1 { - vbus-supply = <®_h1_vbus>; pinctrl-names = "default"; phy_type = "utmi"; dr_mode = "host";
--
2.30.2
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel