[PATCH v3] ARM: dts: aspeed: rainier: Add power-config-full-load gpio

From: Adriana Kobylak <redacted>

Add the power-config-full-load described in:
https://github.com/openbmc/docs/blob/master/designs/device-tree-gpio-naming.md#power-config-full-load

The power-config-full-load gpio is designed to be used to specify how
many power supplies the system should have, in rainier it is 2 or 4.  If
enough power supplies fail so that the system no longer has redundancy
(no longer n+1), the hardware will signal to the Onboard Chip Controller
that the system may be oversubscribed, and performance may need to be
reduced so the system can maintain it's powered on state.

Signed-off-by: Adriana Kobylak <redacted>
---

v2: Update commit message.
v3: Updated gpio name to power-config-full-load to match design doc.

 arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts b/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
index 33fae8ad1305..10bde77fb847 100644
--- a/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
+++ b/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts

@@ -1998,6 +1998,19 @@ eeprom@51 {
 		reg = <0x51>;
 	};
 
+	pca_pres3: pca9552@60 {
+		compatible = "nxp,pca9552";
+		reg = <0x60>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+		gpio-controller;
+		#gpio-cells = <2>;
+
+		gpio-line-names =
+			"", "", "", "", "", "", "", "",
+			"", "", "", "", "", "", "power-config-full-load", "";
+	};
+
 	pca_pres2: pca9552@61 {
 		compatible = "nxp,pca9552";
 		reg = <0x61>;

-- 
2.25.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel