Hi Stephen,

Am 18.10.21 um 22:01 schrieb Stephen Boyd:

Quoting Martin Blumenstingl (2021-10-16 03:50:21)

quoted

Commit 69a00fb3d69706 ("clk: divider: Implement and wire up
.determine_rate by default") switches clk_divider_ops to implement
.determine_rate by default. This breaks composite clocks with multiple
parents because clk-composite.c does not use the special handling for
mux + divider combinations anymore (that was restricted to rate clocks
which only implement .round_rate, but not .determine_rate).

Alex reports:
  This breaks lot of clocks for Rockchip which intensively uses
  composites,  i.e. those clocks will always stay at the initial parent,
  which in some cases  is the XTAL clock and I strongly guess it is the
  same for other platforms,  which use composite clocks having more than
  one parent (e.g. mediatek, ti ...)

  Example (RK3399)
  clk_sdio is set (initialized) with XTAL (24 MHz) as parent in u-boot.
  It will always stay at this parent, even if the mmc driver sets a rate
  of  200 MHz (fails, as the nature of things), which should switch it
  to   any of its possible parent PLLs defined in
  mux_pll_src_cpll_gpll_npll_ppll_upll_24m_p (see clk-rk3399.c)  - which
  never happens.

Restore the original behavior by changing the priority of the conditions
inside clk-composite.c. Now the special rate + mux case (with rate_ops
having a .round_rate - which is still the case for the default
clk_divider_ops) is preferred over rate_ops which have .determine_rate
defined (and not further considering the mux).

Fixes: 69a00fb3d69706 ("clk: divider: Implement and wire up .determine_rate by default")
Reported-by: Alex Bee <redacted>
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
---

Applied to clk-fixes

any chance this can make it in 5.15?

Regards,
Alex

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel