Re: [PATCH v4 11/12] [RFC] firmware: arm_scmi: Add sync_cmds_atomic_replies transport flag

From
Florian Fainelli <f.fainelli@gmail.com>
Date
2021-08-25 16:38:33
Also in
lkml
Reply to
Cristian Marussi, 2021-08-24

On 8/24/2021 3:59 PM, Cristian Marussi wrote:
A flag is added to let the transport signal the core that its handling of
synchronous command messages implies that, after .send_message has returned
successfully, the requested command can be assumed to be fully and
completely executed on SCMI platform side so that any possible response
value is already immediately available to be retrieved by a .fetch_reponse:
in other words the polling phase can be skipped in such a case and the
response values accessed straight away.

Note that all of the above applies only when polling mode of operation was
selected by the core: if instead a completion IRQ was found to be available
the normal response processing path based on completions will still be
followed.
This might actually have to be settable on a per-message basis ideally since we may be transporting short lived SCMI messages for which the completion can be done at SMC time, and long lived SCMI messages (e.g.: involving a voltage change) for which we would prefer a completion interrupt. Jim, what do you think?
-- 
Florian

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Thread (31 messages) 31 messages, 3 authors, last reply 2021-10-04
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help