Hi,

This series adds support for WILC1000 devices on pwrseq-sd8787 driver.
WILC1000 devices needs a minimum delay of 5ms b/w reset and power lines.
Adapt the sd8787 driver for this by adding a new compatible for WILC1000
devices and specify the delay on .data field of struct of_device_id.

Thank you,
Claudiu Beznea

Changes in v3:
- fixed dt binding compilation

Changes in v2:
- changed cover letter title (it was: mmc: pwrseq: sd8787: add support
  for selectable)
- use new compatible in pwrseq-sd8787 driver instead of adding a new
  binding for specifying the delay; with this, the patch 1/1 from v1 is
  not necessary
- adapt patch 3/3 from this version with the new compatible


Claudiu Beznea (3):
  dt-bindings: pwrseq-sd8787: add binding for wilc1000
  mmc: pwrseq: sd8787: add support for wilc1000
  mmc: pwrseq: add wilc1000_sdio dependency for pwrseq_sd8787

Eugen Hristev (1):
  ARM: dts: at91: sama5d27_wlsom1: add wifi device

 .../bindings/mmc/mmc-pwrseq-sd8787.yaml       |  4 +-
 arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi   | 71 +++++++++++++++++++
 drivers/mmc/core/Kconfig                      |  2 +-
 drivers/mmc/core/pwrseq_sd8787.c              | 11 ++-
 4 files changed, 84 insertions(+), 4 deletions(-)

-- 
2.25.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel