On Sat, 2021-07-31 at 11:17 -0600, David Ahern wrote:
On 7/30/21 7:52 PM, Rocco Yue wrote:

quoted

In this way, if the MTU values that the device receives from
the network in the PCO IPv4 and the RA IPv6 procedures are
different, the user space process can read ra_mtu to get
the mtu value carried in the RA message without worrying
about the issue of ipv4 being stuck due to the late arrival
of RA message. After comparing the value of ra_mtu and ipv4
mtu, then the device can use the lower MTU value for both
IPv4 and IPv6.

you are storing the value and sending to userspace but never using it
when sending a message. What's the pointing of processing the MTU in the
RA if you are not going to use it to control message size?

Hi David,

In the requirement of mobile operator at&t in 2021:
AT&T <CDR-CDS-116> Prioritize Lower MTU value:
If the MTU values that the device receives from the network in the PCO
IPv4 <CDR-CDS-110> and the RA IPv6 <CDR-CDS-112> procedures are different,
then the device shall use the lower MTU value for both IPv4 and IPv6.

And in the 3GPP 23.060:
The PDP PDUs shall be routed and transferred between the MS and the GGSN
or P-GW as N-PDUs. In order to avoid IP layer fragmentation between the
MS and the GGSN or P-GW, the link MTU size in the MS should be set to the
value provided by the network as a part of the IP configuration. This
applies to both IPv6 and IPv4.

That means user needs to be able to correctly read the mtu value carried
in the RA message so that user can correctly compare PCO ipv4 mtu and
RA ipv6 mtu.

quoted

@@ -5761,6 +5765,7 @@ static int inet6_set_iftoken(struct inet6_dev *idev, struct in6_addr *token,
 static const struct nla_policy inet6_af_policy[IFLA_INET6_MAX + 1] = {
 	[IFLA_INET6_ADDR_GEN_MODE]	= { .type = NLA_U8 },
 	[IFLA_INET6_TOKEN]		= { .len = sizeof(struct in6_addr) },
+	[IFLA_INET6_RA_MTU]		= { .type = NLA_U32 },
 };
 
 static int check_addr_gen_mode(int mode)

Its value is derived from an RA not set by userspace, so set the type to
NLA_REJECT so that inet6_validate_link_af will reject messages that have
IFLA_INET6_RA_MTU set. You can set "reject_message" in the policy to
return a message that "IFLA_INET6_RA_MTU can not be set".

will do.

Thanks
Rocco
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel