RE: [PATCH net-next] ARM: dts: imx6qdl: Remove unnecessary mdio #address-cells/#size-cells

Hi Fabio,

-----Original Message-----
From: Fabio Estevam <festevam@gmail.com>
Sent: 2021年7月23日 21:16
To: Vladimir Oltean <olteanv@gmail.com>
Cc: David S. Miller <davem@davemloft.net>; Shawn Guo
[off-list ref]; moderated list:ARM/FREESCALE IMX / MXC ARM
ARCHITECTURE [off-list ref]; Joakim Zhang
[off-list ref]; Rob Herring [off-list ref]; netdev
[off-list ref]; open list:OPEN FIRMWARE AND FLATTENED
DEVICE TREE BINDINGS [off-list ref]
Subject: Re: [PATCH net-next] ARM: dts: imx6qdl: Remove unnecessary mdio
#address-cells/#size-cells

Hi Vladimr,

On Fri, Jul 23, 2021 at 10:08 AM Vladimir Oltean [off-list ref] wrote:

quoted

Are you actually sure this is the correct fix? If I look at mdio.yaml,
I think it is pretty clear that the "ethernet-phy" subnode of the MDIO
controller must have an "@[0-9a-f]+$" pattern, and a "reg" property.
If it did, then it wouldn't warn about #address-cells.

Thanks for reviewing it.

After double-checking I realize that the correct fix would be to pass the phy
address, like:

phy: ethernet-phy@1 {
reg = <1>;

Since the Ethernet PHY address is design dependant, I can not make the fix
myself.

I will try to ping the board maintainers for passing the correct phy address.

Thanks.

I prepare this patch to fix dtbs_check when convert fec binding into schema.
I realized that we need a "reg" under phy device node, but I also don't know how to add it since
the phy is obviously not on board. And I check the phy code, it supports auto scan for PHYs with empty
"reg" property.

Best Regards,
Joakim Zhang

Thanks

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel