The original bindings was listing the length of the interrupts as either
1 or 2, depending on the setup. This is also what is enforced by the top
level schema.
However, that is further constrained with an if clause that require
exactly two interrupts, even though it might not make sense on those
devices or in some setups.
Let's remove the clause entirely.
Cc: Denis Ciocca <redacted>
Cc: Jonathan Cameron <jic23@kernel.org>
Cc: Lars-Peter Clausen <lars@metafoo.de>
Cc: Linus Walleij <redacted>
Cc: <redacted>
Signed-off-by: Maxime Ripard <redacted>
---
.../bindings/iio/st,st-sensors.yaml | 41 -------------------
1 file changed, 41 deletions(-)
diff --git a/Documentation/devicetree/bindings/iio/st,st-sensors.yaml b/Documentation/devicetree/bindings/iio/st,st-sensors.yaml
index b2a1e42c56fa..71de5631ebae 100644
--- a/Documentation/devicetree/bindings/iio/st,st-sensors.yaml
+++ b/Documentation/devicetree/bindings/iio/st,st-sensors.yaml
@@ -152,47 +152,6 @@ allOf:
maxItems: 1
st,drdy-int-pin: false
- - if:
- properties:
- compatible:
- enum:
- # Two intertial interrupts i.e. accelerometer/gyro interrupts
- - st,h3lis331dl-accel
- - st,l3g4200d-gyro
- - st,l3g4is-gyro
- - st,l3gd20-gyro
- - st,l3gd20h-gyro
- - st,lis2de12
- - st,lis2dw12
- - st,lis2hh12
- - st,lis2dh12-accel
- - st,lis331dl-accel
- - st,lis331dlh-accel
- - st,lis3de
- - st,lis3dh-accel
- - st,lis3dhh
- - st,lis3mdl-magn
- - st,lng2dm-accel
- - st,lps331ap-press
- - st,lsm303agr-accel
- - st,lsm303dlh-accel
- - st,lsm303dlhc-accel
- - st,lsm303dlm-accel
- - st,lsm330-accel
- - st,lsm330-gyro
- - st,lsm330d-accel
- - st,lsm330d-gyro
- - st,lsm330dl-accel
- - st,lsm330dl-gyro
- - st,lsm330dlc-accel
- - st,lsm330dlc-gyro
- - st,lsm9ds0-gyro
- - st,lsm9ds1-magn
- then:
- properties:
- interrupts:
- maxItems: 2
-
required:
- compatible
- reg--
2.31.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel