[PATCH] mmc: mmci: stm32: check when the voltage switch procedure should be done
From: Yann Gautier <hidden>
Date: 2021-07-01 14:34:14
Also in:
linux-mmc, lkml
Subsystem:
multimedia card (mmc), secure digital (sd) and sdio subsystem, the rest · Maintainers:
Ulf Hansson, Linus Torvalds
From: Christophe Kerello <redacted>
If the card has not been power cycled, it may still be using 1.8V
signaling. This situation is detected in mmc_sd_init_card function and
should be handled in mmci stm32 variant.
The host->pwr_reg variable is also correctly protected with spin locks.
Fixes: 94b94a93e355 ("mmc: mmci_sdmmc: Implement signal voltage callbacks")
Signed-off-by: Christophe Kerello <redacted>
Signed-off-by: Yann Gautier <redacted>
---
drivers/mmc/host/mmci_stm32_sdmmc.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/mmc/host/mmci_stm32_sdmmc.c b/drivers/mmc/host/mmci_stm32_sdmmc.c
index 51db30acf4dc..fdaa11f92fe6 100644
--- a/drivers/mmc/host/mmci_stm32_sdmmc.c
+++ b/drivers/mmc/host/mmci_stm32_sdmmc.c@@ -479,8 +479,9 @@ static int sdmmc_post_sig_volt_switch(struct mmci_host *host, u32 status; int ret = 0; - if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_180) { - spin_lock_irqsave(&host->lock, flags); + spin_lock_irqsave(&host->lock, flags); + if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_180 && + host->pwr_reg & MCI_STM32_VSWITCHEN) { mmci_write_pwrreg(host, host->pwr_reg | MCI_STM32_VSWITCH); spin_unlock_irqrestore(&host->lock, flags);
@@ -492,9 +493,11 @@ static int sdmmc_post_sig_volt_switch(struct mmci_host *host, writel_relaxed(MCI_STM32_VSWENDC | MCI_STM32_CKSTOPC, host->base + MMCICLEAR); + spin_lock_irqsave(&host->lock, flags); mmci_write_pwrreg(host, host->pwr_reg & ~(MCI_STM32_VSWITCHEN | MCI_STM32_VSWITCH)); } + spin_unlock_irqrestore(&host->lock, flags); return ret; }
--
2.17.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel