Re: [PATCH 2/2] ARM: dts: owl-s500-roseapplepi: Add ethernet support

On Fri, Jun 11, 2021 at 12:09:40PM +0530, Manivannan Sadhasivam wrote:

On Fri, Jun 11, 2021 at 09:31:47AM +0300, Cristian Ciocaltea wrote:

quoted

On Fri, Jun 11, 2021 at 11:26:06AM +0530, Manivannan Sadhasivam wrote:

quoted

On Fri, Jun 11, 2021 at 12:09:22AM +0300, Cristian Ciocaltea wrote:

quoted

Add pinctrl configuration for enabling the Ethernet MAC on RoseapplePi
SBC. Additionally, provide the necessary properties for the generic S500
ethernet node in order to setup PHY and MDIO.

Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@gmail.com>
---
 arch/arm/boot/dts/owl-s500-roseapplepi.dts | 56 ++++++++++++++++++++++
 1 file changed, 56 insertions(+)

diff --git a/arch/arm/boot/dts/owl-s500-roseapplepi.dts b/arch/arm/boot/dts/owl-s500-roseapplepi.dts
index b8c5db2344aa..bffabc7eaa50 100644
--- a/arch/arm/boot/dts/owl-s500-roseapplepi.dts
+++ b/arch/arm/boot/dts/owl-s500-roseapplepi.dts

[...]

quoted

quoted

quoted

+	mdio {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		reset-gpios = <&pinctrl 88 GPIO_ACTIVE_LOW>; /* GPIOC24 */
+		reset-delay-us = <10000>;
+		reset-post-delay-us = <150000>;

reset-* properties belong to "ethernet-phy" node. Also, while adding new nodes
please run the dtbs_check and try to address the warnings.

The properties are those described in Documentation/devicetree/bindings/net/mdio.yaml

Do you mean the reset properties are applicable for all PHYs in this SoC?

Actually there is only one PHY connected. I've also checked the vendor
code and didn't notice any special handling for the PHY reset.

quoted

The dtbs_check doesn't report any issues in my case, usually this
happens when dtschema is not updated to the latest version. I always
run the following command after rebasing to a new kernel version:

  pip3 install --upgrade dtschema

That's good!

Thanks,
Mani

quoted

Thanks for the review,
Cristi

quoted

Thanks,
Mani

quoted

+
+		eth_phy: ethernet-phy@3 {
+			reg = <0x3>;
+			max-speed = <100>;
+			interrupt-parent = <&sirq>;
+			interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
+		};
+	};
+};
+
 &twd_timer {
 	status = "okay";
 };
-- 
2.32.0

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel