[PATCH] arm64: dts: allwinner: a64-sopine-baseboard: change RGMII mode to TXID

Although the schematics of Pine A64-LTS and SoPine Baseboard shows both
the RX and TX internal delay are enabled, they're using the same broken
RTL8211E chip batch with Pine A64+, so they should use TXID instead, not
ID.

In addition, by checking the real components soldered on both a SoPine
Baseboard and a Pine A64-LTS, RX delay is not enabled (GR69 soldered and
GR70 NC) despite the schematics says it's enabled. It's a common
situation for Pine64 boards that the NC information on schematics is not
the same with the board.

So the RGMII delay mode should be TXID on these boards.

Fixes: c2b111e59a7b ("arm64: dts: allwinner: A64 Sopine: phy-mode rgmii-id")
Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
---
 arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts
index e22b94c83647..5e66ce1a334f 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts

@@ -79,7 +79,7 @@ &ehci1 {
 &emac {
 	pinctrl-names = "default";
 	pinctrl-0 = <&rgmii_pins>;
-	phy-mode = "rgmii-id";
+	phy-mode = "rgmii-txid";
 	phy-handle = <&ext_rgmii_phy>;
 	phy-supply = <&reg_dc1sw>;
 	status = "okay";

-- 
2.30.2

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

On Wed, Jun 09, 2021 at 04:38:43PM +0800, Icenowy Zheng wrote:

Although the schematics of Pine A64-LTS and SoPine Baseboard shows both
the RX and TX internal delay are enabled, they're using the same broken
RTL8211E chip batch with Pine A64+, so they should use TXID instead, not
ID.

In addition, by checking the real components soldered on both a SoPine
Baseboard and a Pine A64-LTS, RX delay is not enabled (GR69 soldered and
GR70 NC) despite the schematics says it's enabled. It's a common
situation for Pine64 boards that the NC information on schematics is not
the same with the board.

So the RGMII delay mode should be TXID on these boards.

Fixes: c2b111e59a7b ("arm64: dts: allwinner: A64 Sopine: phy-mode rgmii-id")
Signed-off-by: Icenowy Zheng <icenowy@aosc.io>

Applied, thanks
Maxime