Re: [PATCH 0/4] drm/vc4: Add support for the BCM2711 VEC

Hi Maxime

On Thu, 20 May 2021 at 16:03, Maxime Ripard [off-list ref] wrote:

Hi,

The composite output in the BCM2711 is dealt using the VEC. While the earlier
SoCs were properly supported, it wasn't functional on the BCM2711. Add the
needed support from the RPi downstream kernel.

Thanks for upstreaming these.
As far as I'm concerned they're all good, but DT bindings aren't an
area of expertise for me.

Patches 1&3:
Reviewed-by: Dave Stevenson <dave.stevenson@raspberrypi.com>
Patches 2&4:
Acked-by: Dave Stevenson <dave.stevenson@raspberrypi.com>

This is going to need firmware from 23rd March 2021 or later in order
to ensure that the VEC can use an integer divider from the PLL. PLLC
was rejigged to run at 2592MHz so that /24 gives the VEC the 108MHz
clock it requires. (Before that it needed a special config.txt option
to set the PLLs appropriately).

 Dave

Maxime

Mateusz Kwiatkowski (4):
  drm/vc4: Fix clock source for VEC PixelValve on BCM2711
  dt-bindings: display: bcm2835-vec: Add BCM2711 compatible
  drm/vc4: Separate VEC compatible variants
  ARM: boot: dts: bcm2711: Add BCM2711 VEC compatible

 .../bindings/display/brcm,bcm2835-vec.yaml    |  4 ++-
 arch/arm/boot/dts/bcm2711.dtsi                |  1 +
 drivers/gpu/drm/vc4/vc4_crtc.c                |  2 +-
 drivers/gpu/drm/vc4/vc4_vec.c                 | 27 +++++++++++++++----
 4 files changed, 27 insertions(+), 7 deletions(-)

--
2.31.1

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel