[PATCH v2 2/7] ARM: dts: sun8i: v3s: add DMA properties to peripherals supporting DMA

@@ -285,6 +285,8 @@ crypto@1c15000 {
 			interrupts = <GIC_SPI 80 IRQ_TYPE_LEVEL_HIGH>;
 			clocks = <&ccu CLK_BUS_CE>, <&ccu CLK_CE>;
 			clock-names = "ahb", "mod";
+			dmas = <&dma 16>, <&dma 16>;
+			dma-names = "rx", "tx";
 			resets = <&ccu RST_BUS_CE>;
 			reset-names = "ahb";
 		};

@@ -446,6 +448,8 @@ uart0: serial@1c28000 {
 			reg-shift = <2>;
 			reg-io-width = <4>;
 			clocks = <&ccu CLK_BUS_UART0>;
+			dmas = <&dma 6>, <&dma 6>;
+			dma-names = "rx", "tx";
 			resets = <&ccu RST_BUS_UART0>;
 			status = "disabled";
 		};

@@ -457,6 +461,8 @@ uart1: serial@1c28400 {
 			reg-shift = <2>;
 			reg-io-width = <4>;
 			clocks = <&ccu CLK_BUS_UART1>;
+			dmas = <&dma 7>, <&dma 7>;
+			dma-names = "rx", "tx";
 			resets = <&ccu RST_BUS_UART1>;
 			status = "disabled";
 		};

@@ -468,6 +474,8 @@ uart2: serial@1c28800 {
 			reg-shift = <2>;
 			reg-io-width = <4>;
 			clocks = <&ccu CLK_BUS_UART2>;
+			dmas = <&dma 8>, <&dma 8>;
+			dma-names = "rx", "tx";
 			resets = <&ccu RST_BUS_UART2>;
 			pinctrl-0 = <&uart2_pins>;
 			pinctrl-names = "default";

@@ -547,6 +555,8 @@ spi0: spi@1c68000 {
 			interrupts = <GIC_SPI 65 IRQ_TYPE_LEVEL_HIGH>;
 			clocks = <&ccu CLK_BUS_SPI0>, <&ccu CLK_SPI0>;
 			clock-names = "ahb", "mod";
+			dmas = <&dma 23>, <&dma 23>;
+			dma-names = "rx", "tx";
 			pinctrl-names = "default";
 			pinctrl-0 = <&spi0_pins>;
 			resets = <&ccu RST_BUS_SPI0>;