[PATCH net v2 0/2] Change phy-mode to RGMII-ID to enable delay pins for RTL8211E

UniPhier PXs2, LD20, and PXs3 boards have RTL8211E ethernet phy, and the
phy have the RX/TX delays of RGMII interface using pull-ups on the RXDLY
and TXDLY pins.

After the commit bbc4d71d6354 ("net: phy: realtek: fix rtl8211e rx/tx
delay config"), the delays are working correctly, however, "rgmii" means
no delay and the phy doesn't work. So need to set the phy-mode to
"rgmii-id" to show that RX/TX delays are enabled.

Changes since v1:
- Fix the commit message

Kunihiko Hayashi (2):
  ARM: dts: uniphier: Change phy-mode to RGMII-ID to enable delay pins
    for RTL8211E
  arm64: dts: uniphier: Change phy-mode to RGMII-ID to enable delay pins
    for RTL8211E

 arch/arm/boot/dts/uniphier-pxs2.dtsi             | 2 +-
 arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi | 2 +-
 arch/arm64/boot/dts/socionext/uniphier-pxs3.dtsi | 4 ++--
 3 files changed, 4 insertions(+), 4 deletions(-)

-- 
2.7.4


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel