Quoting quanyang.wang@windriver.com (2021-03-30 05:17:01)

From: Quanyang Wang <redacted>

If there is a IOCTL_SET_PLL_FRAC_MODE request sent to ATF ever,
we shouldn't skip invoking PM_CLOCK_ENABLE fn even though this
pll has been enabled. In ATF implementation, it will only assign
the mode to the variable (struct pm_pll *)pll->mode when handling
IOCTL_SET_PLL_FRAC_MODE call. Invoking PM_CLOCK_ENABLE can force
ATF send request to PWU to set the pll mode to PLL's register.

There is a scenario that happens in enabling VPLL_INT(clk_id:96):
1) VPLL_INT has been enabled during booting.
2) A driver calls clk_set_rate and according to the rate, the VPLL_INT
   should be set to FRAC mode. Then zynqmp_pll_set_mode is called
   to pass IOCTL_SET_PLL_FRAC_MODE to ATF. Note that at this point
   ATF just stores the mode to a variable.
3) This driver calls clk_prepare_enable and zynqmp_pll_enable is
   called to try to enable VPLL_INT pll. Because of 1), the function
   zynqmp_pll_enable just returns without doing anything after checking
   that this pll has been enabled.

In the scenario above, the pll mode of VPLL_INT will never be set
successfully. So adding set_pll_mode to check condition to fix it.

Signed-off-by: Quanyang Wang <redacted>
Tested-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
---

Any Fixes tag?

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel